Dynamic DX2-GYRO Adendum Panduan Instalasi - Halaman 5
Jelajahi secara online atau unduh pdf Adendum Panduan Instalasi untuk Unit Kontrol Dynamic DX2-GYRO. Dynamic DX2-GYRO 20 halaman. The ultimate powerchair control solution
Halaman Cetak
1 Introduction to the DX2-PMA90LG
The DX2-PMA90LG is a DX2-PMA Power Module variant that can connect to a
DX2-GYRO Module.
The Gyro module can help to keep the chair straight on challenging terrain by
measuring the physical movement of the chair. If the chair does not go in the
intended direction, the Gyro power module makes small corrections until the chair
does go in the intended direction.
GYRO
: Issue 2.03 - May 2012
GBK65148
Warning:
Gyro Control cannot be used inside moving vehicles such as buses or trains. If
a chair with Gyro Control is used on a bus or a train, make sure that either the
DX System is powered off or that a non-Gyro stabilised Drive Profile is selected
before the vehicle starts moving.
The Gyro module is not operational as long as the joystick is in the neutral
position.
Note:
The Gyro control is designed to operate correctly during tyre slip. However, if
extreme tyre slip occurs, the Gyro may not be able to correct the direction of
the chair anymore. In this case, a Gyro fault may occur and the chair may
come to a sudden stop. To reset the Gyro fault, turn the power off and on.
Note:
The DX2-PMA90LG is a variant of the DX2-PMA Power Module family.
This document is an addendum to the DX2-PMA power Module installation
manual. Read the DX2-PMA Power Module installation manual before
reading this addendum.
All warnings and configurations presented in the DX2-PMA installation
manual are also applicable to the DX2-PMA90LG, except where specifically
stated differently in this addendum.
5