ADEMCO 5806 Petunjuk Instalasi

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Alarm Asap ADEMCO 5806. ADEMCO 5806 4 halaman. Smoke detector with built-in wireless transmitter
Juga untuk ADEMCO 5806: Petunjuk Instalasi (5 halaman)

Halaman Cetak

ADEMCO LIMITED WARRANTY

Alarm Device Manufacturing Company, 165 Eileen Way, Syosset, New York 11791, a

Division of Pittway Corporation, its divisions, subsidiaries, affiliates, and MZEP, Moscow,

Russia ("Seller"), warrants its products to be in conformance with its own plans and

specifications and to be free from defects in materials and workmanship under normal

use and service for 18 months from the date stamp control on the product or, for

products not having Seller's date stamp, for 12 months from date of original purchase

unless the installation instructions or catalog sets forth a shorter period, in which case

the shorter period shall apply. Seller's obligation shall be limited to repairing or replacing,

at its option, free of charge for materials or labor, any product which is proved not in

compliance with Seller's specifications or proves defective in materials or workmanship

under normal use and service. Seller shall have no obligation under this Limited

Warranty or otherwise if the product is altered or improperly repaired or serviced by

anyone other than Ademco factory service. For warranty service, return product,

transportation prepaid, to Ademco Factory Service, 165 Eileen Way, Syosset, New York

11791 via your local authorized distributor.

THERE ARE NO WARRANTIES, EXPRESS OR IMPLIED, OF MERCHANTABILITY,

OR FITNESS FOR A PARTICULAR PURPOSE OR OTHERWISE, WHICH EXTEND

BEYOND THE DESCRIPTION ON THE FACE HEREOF. IN NO CASE SHALL SELLER

BE LIABLE TO ANYONE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES

FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED, OR

UPON ANY OTHER BASIS OF LIABILITY WHATSOEVER, EVEN IF THE LOSS OR

DAMAGE IS CAUSED BY THE SELLER'S OWN NEGLIGENCE OR FAULT.

Seller does not represent that the products it sells may not be compromised or

circumvented; that the products will prevent any personal injury or property loss by

burglary, robbery, fire or otherwise; or that the products will in all cases provide adequate

warning or protection. Customer understands that a properly installed and maintained

alarm may only reduce the risk of a burglary, robbery, fire or other events occurring

without providing an alarm, but it is not insurance or a guarantee that such will not occur

or that there will be no personal injury or property loss as a result. CONSEQUENTLY,

SELLER SHALL HAVE NO LIABILITY FOR ANY PERSONAL INJURY, PROPERTY

DAMAGE OR OTHER LOSS BASED ON A CLAIM THE PRODUCT FAILED TO GIVE

WARNING. However, if Seller is held liable, whether directly or indirectly, for any loss or

damage arising under this Limited Warranty or otherwise, regardless of cause or origin,

Seller's maximum liability shall not in any case exceed the purchase price of the product,

which shall be the complete and exclusive remedy against Seller. This warranty replaces

any previous warranties and is the only warranty made by Seller on this product. No

increase or alteration, written or verbal, of the obligations of this Limited Warranty is

authorized.

165 Eileen Way, Syosset, New York 11791

àN6353V4fä

N6353V4 5/98

INSTALLATION INSTRUCTIONS

For use with QED control panels ONLY!

General Information

The Ademco No. 5806 Photoelectric

Smoke Detector/Transmitter is intended for

use with wireless alarm systems that

support 5800 series devices, and contains

a built-in transmitter which can send alarm,

supervisory

and

battery

condition

messages

the

system's

QED

receiver/control unit. Refer to the wireless

system's instructions for the maximum

number of transmitters that can be

supported.

Alarms: The smoke detector is powered

by two 9-volt batteries and will sound its

built-in horn when smoke reaches the

detector (the LED indicator will also flash

rapidly). A message will also be sent to the

wireless QED control and the smoke

detector's ID number will be displayed at

the keypad. The alarm message will be

transmitted every 4 seconds, until the

smoke condition has cleared and the

detector has reset. About 1 second after

the horn has stopped, a Restore message

will be transmitted to the QED control and

it will then be possible to clear the ID

number from the display. During normal or

low battery conditions, the LED indicator

will flash about once every 40 seconds.

Low Battery: The detector indicates a low

battery condition by emitting a "chirp"

about once every 40 seconds. A low

battery message will be sent to the QED

control unit upon any transmission

TO REMOVE

TO SECURE

INDICATOR LIGHT.

FLASHES ONCE

EVERY 40 SECS

DURING NORMAL

OPERATION

SENSING

CHAMBER

OPENINGS

TEST BUTTON

Previous Menu

N6353V4 5/98

5806

Smoke Detector With Built-In

Wireless Transmitter

following the first battery chirp (with the

detector's ID number displayed at the

keypad). The battery should be replaced

within 30 days following the low battery

signals.

False Alarm Protection: In order to

reduce the possibility of false alarms due to

cigarette smoke, dust, steam, insects, etc.,

the detector will not transmit an alarm

signal until its horn has sounded

continuously for about 6 seconds. A delay

also occurs when testing the detector.

Therefore, the test button must be held

down for about 20 seconds before the horn

will sound. The first alarm signal will be

transmitted within 6 seconds after the horn

sounds.

Programming: Note that the QED control

system must "enroll" the smoke detector's

ID during installation of the system. The

QED control should be programmed to

"enroll" the 5806 as an "RF" type unit (i.e.,

supervised RF). See the PROGRAMMING

section in this instruction book and the

QED control unit's Installation Instructions

for further details.

Tamper Protection: The detector has

provision for a tamper function if desired.

When the tamper function is enabled, the

detector will cause a CHECK to be

displayed if it is removed from its installed

location. See TAMPER PROTECTION for

detailed instructions.

Battery Installation

And Replacement

The 5806 is equipped with two 9 -

volt batteries, which can double

the

time

between

battery

replacement (compared to a

single 9-volt alkaline battery).

Refer to the "Specifications"

section for acceptable batteries.

The batteries should be changed

within 30 days following the low

battery beeps (about once every

40 seconds). There will also be

a low battery display on the

system's keypad. Be sure to

replace BOTH batteries with

fresh ones.

Important: Do not mix battery

types.