Automationdirect.com Productivity 2000 P2-08DA-2 Manual - Halaman 2
Jelajahi secara online atau unduh pdf Manual untuk Unit Kontrol Automationdirect.com Productivity 2000 P2-08DA-2. Automationdirect.com Productivity 2000 P2-08DA-2 8 halaman. Analog output
Halaman Cetak
General Specifications
Operating Temperature
0º to 60ºC (32º to 140ºF)
Storage Temperature
-20º to 70ºC (-4º to 158ºF)
Humidity
5 to 95% (non-condensing)
Environmental Air
No corrosive gases permitted
Vibration
IEC60068-2-6 (Test Fc)
Shock
IEC60068-2-27 (Test Ea)
Field to Logic Side Isolation
1800VAC applied for 1 second
Insulation Resistance
> 10MΩ @ 500VDC
Heat Dissipation
150mW
Enclosure Type
Open Equipment
Module Keying to Backplane
Electronic
Module Location
Any I/O slot in a Productivity2000 System
Use ZIPLink Wiring System or removable terminal block
Field Wiring
(not included). See "Wiring Options" on page 5.
See the "EU Directive" topic in the Productivity Suite
EU Directive
Help File. Information can also be obtained at:
www.productivity2000.com
Connector Type (not included) 18-position removable terminal block
Weight
90g (3.2 oz)
UL508 File E139594, Canada & USA
Agency Approvals
CE (EN61131-2*)
*Meets EMC and Safety requirements. See the D.O.C. for details.
2
www.productivity2000.com
Output Specifications
Output Channels
Output Ranges
Signal Resolution
Resolution Value of LSB
(least significant bit)
Data Range
Output Type
Output Value in Fault Mode
Load Impedance
Maximum Capacitive Load (voltage output) 0.01 μF
Maximum Inductive Load (Current Output)
Allowed Load Type
Maximum Inaccuracy
Maximum Full Scale Calibration Error
Maximum Offset Calibration Error
Accuracy vs. Temperature
Maximum Crosstalk at DC, 50Hz and 60Hz -96dB, 1 LSB
Linearity Error
Output Stability and Repeatability
Output Ripple
Output Setting Time
All Channel Update Rate
Maximum Continuous Overload
Type of Output Protection
Output Signal (power-up,-down) or at
Power Up and Power Down
External Power Supply Required
Tech Support 770-844-4200
8
±10VDC
16-bit
±10V = 305μV/count
1 LSB = 1 count
-32768 to +32767 counts
Voltage: 10mA max
0V
≥1000Ω
1mH
Grounded
0.1% of range
(including temperature drift)
±0.025% of range maximum
±0.025% of range maximum
±25ppm/°C max full scale calibration change
(±0.0025% of range/°C)
±16 LSB maximum (±0.025% of full scale)
Monotonic with no missing codes
±10 LSB after 10 minute warm-up (typical)
0.05% of full scale
300μs max, 5μs min (full scale change)
1ms
Outputs current limited to 40mA typical
Continous overloads on multiple outputs can damage
the module.
0.1 μF Transient Suppressor
0V
24VDC (-20% / +25%), 150mA