ActivePure Induct Guardian I Manual - Halaman 7
Jelajahi secara online atau unduh pdf Manual untuk Pembersih Udara ActivePure Induct Guardian I. ActivePure Induct Guardian I 16 halaman.
FIBERGLASS DUCTWORK INSTALLATION (CONTINUED)
5. Remove backing from the mounting
plate adhesive gasket.
7. Insert (4) toggle bolts into 3/8" holes
in duct. Be sure toggle anchors open
after inserting.
9. Insert unit into opening. Be sure the air
will pass through the ActivePure
honeycomb matrix.
NOTE: Unit requires continuous power. Do not install where power to the unit will be cycled on and off.
6. Insert (4) 2" Threaded bolts into screw
8. Center large opening in the mounting plate
over 3.5" opening in duct and press plate
to duct. The adhesive gasket will hold the
mounting plate into place. Tighten toggle
bolts - DO NOT OVERTIGHTEN.
10. Secure the unit to the mounting plate
Cell
®
holes at corners of mounting plate.
Attach (4) toggle bolt anchors to ends of
threaded bolts.
with four (4) thumb nuts.
Stud
7