Dynamic Engineering PCIe8LXMCX2CB Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kartu PCI Dynamic Engineering PCIe8LXMCX2CB. Dynamic Engineering PCIe8LXMCX2CB 20 halaman. Pcie 8 lane 2 position xmc compatible carrier. connector bus version

Halaman Cetak

FIGURE 1

PCIE8LXMCX2CB JN4/JN6 INTERFACE STANDARD

FIGURE 2

PCIE8LXMCX2CB RESISTOR SELECTION IO

FIGURE 3

PCIE8LXMCX2CB RESISTOR SELECTION CONNECTOR

Product Description

PCIe8LXMCX2CB is part of the Dynamic Engineering PCIe and XMC Compatible family

of modular I/O components. PCIe8LXMCX2CB adapts 2 XMC's to one PCIe slot.

Embedded applications frequently require real time processing coupled with special

purpose IO. With PCIe8LXMCX2CB's two XMC positions; a PrXMC can be matched

with another XMC to make a high bandwidth processing node. The PrXMC can

communicate with the host for set-up, and then use the local bus to control and transfer

data with the special purpose IO card.

The CB model has a Connector Bus between the two XMC rear IO connectors. 0 ohm

resistors are used to select which lines are cross-connected and which go to the

standard IO options. The resistors are located front and back with almost "0" stub

length for the unused feature. The connections are impedance controlled and matched

length routed as differential pairs. 100 ohms.

A selection table is provided to help with resistor stuffing selection. Both of the

corresponding CB resistors will need to be installed to make the CB connection. For

example IO0_0P can be connected to IO1_0P by selection of both CB resistors for that

line. The standard IO connections will normally not be selected in this case, and can

be if it makes sense for your system.

Since there are 64 rear IO lines per XMC and each need 4 resistors; a total of 512

resistors are available. Too many to have a standardized table of options. Contact

Dynamic Engineering with your requirement. We will create a new -# to cover your

configuration. A small charge is required to cover the cost of an updated programming

file for the PnP and test program.

select which connector is tied to the IO. This can be on a signal by signal basis.

Either, neither, both. 2

List of Figures

select which IO to connect the selected connections. See

Embedded Solutions

Page 4