Celexon DELUXX 1000004533 Panduan Pengguna - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Layar Proyeksi Celexon DELUXX 1000004533. Celexon DELUXX 1000004533 12 halaman. Cinema electric screen (tension)
Halaman Cetak
Operation of the screen
Remote control:
The delivery of the screen includes an infrared and a radio remote control. To use the
infrared remote control please use the enclosed IR receiver (q). Insert the jack plug
into the „ext. IR port „on the left side of the screen housing and orient the receiver so
that it has visual contact with the IR remote control.
Operating the remote control
1) Press the „Up" button on the remote control. The screen will
2) Press the „Stop" button on the remote control. The movement of
3) Press the „Down" button on the remote control. The screen will
Pairing the radio remote control:
The radio remote control is already paired with the integrated receiver at the
factory. If the pairing is forgotten, please proceed as follows:
1) Press the „UP" button for 3 seconds until the LED of the remote control lights
up, then connect the power cable to the screen. A beep confirms the pairing
mode that has been started.
2) Release the „up" button when you hear the beep.
3) Briefly press and release the „up" button. When the beep sounds 3 times
quickly, the remote control pairing is complete.
Trigger:
With the trigger connection, the screen can automatically go up and down when
the projector is turned on and off. To do this, connect the screen via the trigger
connection to the trigger output of your projector. It may be necessary to enable
the trigger output of your projector software so that the projector sends the
control signals to the screen. For further information please refer to the operating
instructions of your device or contact the manufacturer of the projector.
Input voltage of trigger connection:
DC / AC 5V - DC / AC 20V
automatically drive to the upper end position and automatically
stop.
the screen stops immediately.
automatically drive to the lower end position and automatically
stop.
10 9