HIFEI Technology Fulcrum Series Manual - Halaman 10
Jelajahi secara online atau unduh pdf Manual untuk Pengontrol HIFEI Technology Fulcrum Series. HIFEI Technology Fulcrum Series 12 halaman. Brushless speed controller
Halaman CetakFulcrum Pro/Pro+ 300A Brushless Speed Controller Manuals
IV F: Logger Configuration
—Click tab ' Logger Configuration' to change setting logger.
Cycle Record: 'Not reverse' indicates the data logger cannot record any more when the space
is filled up; 'reverse' indicates the data logger can record indefinitely by overlapping the former data
and do a cycle. ' Not reverse' is the default.
Sample Rate is the frequency by which data logger samples the power data during
running. The default setting is 3 per second.
Please refer the following form about the recording time and minimum running time when set
sampling rate at different options.
Possible Recording Time means longest time data logger can record with the set sampling rate.
Minimum Running Time: ESC must run longer than the minimum running time, otherwise the
software can not read and display the data on the PC window.
Note:
please DO NOT power off ESC abnormally while not moving throttle back to zero
position
,
otherwise power data will be unavailable
www.hifei.com
.
Page 19
Fulcrum Pro/Pro+ 300A Brushless Speed Controller Manuals
V Trouble shooting
Trouble
1. The battery voltage exceeds
the range of ESC's working
When connect ESC to battery,
voltage. May it is too low or
there is no two power beeps
too high.
emitted from brushless motor.
2. Motor is damaged, or the ESC
is not well connected with
motor.
1. Battery voltage discharge and
drop down to the set low cut-
Motor shut down suddenly even at
off voltage, the ESC cut-off
full throttle or when not decrease
output to motor to protect the
the throttle.
battery.
2. Temperature protection
When
connect
ESC
to
PC
1. There is loose between USB
according to the instructions, it
Linker to 'USB port' of PC.
still cannot connect the ESC to PC
2. The com port is not correct.
succefull for programming.
3.
ESC's receiver lead to USB
Linker is wrongly connected.
www.hifei.com
Possible reason
Shoot methods
1. Check battery's voltage and
change suitable battery pack.
2.Check the connectors, ensure
ESC is tightly connected with
motor. Check motor whether it is
good.
1. Please stop the running and
change a new battery pack.
2. Stop running for a while until
the ESC's temperature decrease
and recover to be normal.
1.Plug out the USB Linker from
the PC, and re-plug it in.
2. Check the correct com port.
3.Check the connecting polarity
between ESC to USB Linker.
Page 20