Dynamics Dings 6-71010-114 Petunjuk

Jelajahi secara online atau unduh pdf Petunjuk untuk Peralatan Industri Dynamics Dings 6-71010-114. Dynamics Dings 6-71010-114 4 halaman. Double shafted brake with foot mount

Halaman Cetak

IMPORTANT

Read carefully before attempting to assemble, install,

operate or maintain the product described. Protect yourself

and others by observing all safety information. Failure to

comply with instructions could result in personal injury

and/or property damage! Retain instructions for future

reference. When unpacking the brake, inspect it carefully

for damage that may have occurred during transit.

WARNING

Brake performance and features must be carefully matched to the

requirements of the application.

Consideration must be given to torque requirements, especially where

an overhauling condition exists, as well as thermal capacity, ambient

temperature, atmospheric explosion hazards, type of enclosure and

any other unusual conditions.

Improper selection and installation of a brake and/or lack of mainte-

nance may cause brake failure which could result in damage to prop-

erty and/or injury to personnel.

If injury to personnel could be caused by brake failure, additional

means must be provided to insure safety of personnel.

DESCRIPTION

This brake is direct acting, electromagnetically released and spring set.

It uses rotating and stationary disc contact to supply positive braking

action. It retains quick release and setting capabilities at all times.

Simplicity of design has reduced maintenance to an absolute minimum.

As with any electromechanical equipment, however, periodic inspection

and adjustment will assure optimum performance. As the friction disc

wears, the magnet gap will increase. The magnet gap should be checked

periodically and adjusted when necessary. This brake is offered as a

standard (NEMA 2) enclosure.

4740 WEST ELECTRIC AVENUE

MILWAUKEE, WI 53219

PHONE 414/672-7830

Double Shafted Brake

INSTALLATION

Refer to Figures 1 & 2

Insert key into motor shaft keyway. Key length to be as

shown below for models designated.

Key must be full length

of keyway and flush with

end of shaft

Used on all models except

71010, 71015, 72025, and

72035 with 1-1/8" dia. shaft.

Install brake into location using bolt holes in foot mounting

bracket. Connect coil leads per appropriate diagram.

Figure 1. Wiring Diagram

FAX 414/672-5354

Bulletin No. BK4760 (5/14)

70 Series

with Foot Mount

Instructions

Key to extend to

end of keyway

Model X ± 1/32

71010

1-15/16

71015

72025

2-7/16

72035

For models 71010, 71015,

72025 and 72035 with

1-1/8" dia. shaft.