8level ALRM-DS Manual

Jelajahi secara online atau unduh pdf Manual untuk Sensor Keamanan 8level ALRM-DS. 8level ALRM-DS 2 halaman.

Halaman Cetak

Thank you for purchasing our product. Please read this manual carefully before you use it. This manual covers

the ALRM-DS detector.

NOTE! The manufacturer reserves the right to alter the device parameters and operating methods without a

prior notice. Due to continuous modiﬁcations, some of the functions described in this manual may slightly

differ from reality. The author reserves the right to amend the information contained herein in full or in part

without a prior notice.

1. Characteristics

The door detector may be installed on doors, windows or other tiltable elements. If the alarm is armed and

someone opens the door or window, the detector will send a signal to the alarm control panel and activate the

alarming procedure. The detector is made of components that ensure a low power consumption and this a

longer life of the batteries.

The red LED indicates normal operation

The yellow LED indicates that

the battery is low

2. Features

• Low power consumption

• LED indicator of low battery

• Indication of low battery to the alarm control panel

• Door open/closed detection.

ALRM-DS

3. Technical specification

• Supply DC voltage: 3V (2 x AAA battery)

• Power consumption at idle: ≤3uA

• Power consumption during operation: ≤8uA

• Remote signal range: up to 400m with external antenna or up to 200m with internal antenna

• Signal frequency: 433MHz

• Operating temperature: -20°C to +60°C

• Humidity: ≤80%

• Sensor dimensions (L*W*H): 79*37*20.5mm

• Magnet dimensions (L*W*H): 56*14*15.5mm

4. Internal diagram and method of installation

Open/Close – the detector sends signals regardless of whether the magnet is close or far.

Normal – the detector sends signals only when the magnet is far.

5. Installation

Press the upper section of the housing to release the latch securing the front cover.

Once you remove the cover, insert two AAA batteries. Pay attention to polarity.

Install the detector on a door or window frame. Install the magnet on a door or window leaf. The device should

be installed with screws or a double-sided stick tape.

Install the magnet on the right side of the detector. The detector-to-magnet distance should not exceed 1 cm.

Do not install the detector in locations where there are many metals or electric cables.

To add the detector to your alarm system, switch the system control panel to detector adding mode, and then

call the detector signal by positioning the detector close to the control panel and moving the magnet and

detector apart.

The detector can cooperate with our 8level ALRM-KIT-BASE alarm control panel. To pair the detector with the

control panel, proceed according to the manual attached to your ALRM-KIT-BASE alarm.

Note! When the detector indicates that the battery is low, immediately replace the battery to maintain the

system in operation.

Mode switch