Galactron MK 2225 Panduan Pemilik - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat Galactron MK 2225. Galactron MK 2225 10 halaman.

13. FRONT PANEL

On the front panel there are 3 controls, Source Selection, Volume, Power On - Off.

On the front panel there are:

POWER

Red LED.

It lights red when put in the "OFF" the power switch, it indicates that the amplifier is connected to the

network, but in stand-by mode.

WARM-UP

In the moment of switching on the amplifier, for about 30 seconds, the red LED will flash with the selected

input source, this means the WARM-UP.

During this short period, you cannot use the amplifier.

During this stage, it is normal that there is a slight background noise.

When the LED will stop flashing and the volume knob will rise with a minimum sound pressure, then your

Galactron will be ready.

To have the top of the sonic performance, the amplifier must be able to reach a certain thermal stability.

Indicates that you have selected the input L1.

Indicates that you have selected the input L2.

Indicates that you have selected the input L3.

Indicates that you have selected the input L4.

Indicates that you have selected the input L5.

VOLUME

The knob is equipped with an internal motor that raising and lowering the volume from the remote control

knob rotates, indicating the sound pressure you require.

INFRA RED DETECTOR

All commands to the amplifier are communicated via this sensor. The infra red detector should be kept free

of obstruction, and the front of the amplifier should face towards the listening area.

REMOTE CONTROL

There are 8 buttons on the remote control.

Pressing this button turns on the amplifier and select the input L1.

Pressing this button turns on the amplifier and select the L2 input.

Pressing this button turns on the amplifier and select the input L3.

Pressing this button turns on the amplifier and select the input L4.

Pressing this button turns on the amplifier and select the input L5.

VOLUME

Pressing these keys (L5 + Mute) you are controlling the increase in the volume of the amplifier.

MUTE

Pressing this button will lower the volume by 20 dB. To restore the original volume, just press.

STAND-BY

By pressing this button (Volume + / - at the same time) you turn off the amplifier, putting it in standby mode:

in this condition the microprocessor control is active, while the amplifier itself is turned off.

To turn the amplifier, simply press one of the buttons for selecting the input 1,2,3 or 4.

BATTERY COMPARTMENT

The remote control to operate at need 4 AAA batteries (AAA). Below a certain level of charge the remote

control stops functioning completely.