2gig Technologies 2GIG BRDG1 900 Petunjuk Instalasi

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Router Jaringan 2gig Technologies 2GIG BRDG1 900. 2gig Technologies 2GIG BRDG1 900 4 halaman. Bridge ip communicator

Halaman Cetak

2GIG-BRDG1-900

Go!Bridge IP Communicator

INSTALLATION INSTRUCTIONS

The Go!Bridge™ IP Communicator (2GIG‐BRDG1‐900) provides

Internet connectivity between the monitoring service's Central Station

and the Go!Control® Panel (requires the 900 MHz Transceiver (2GIG‐

XCVR)).

It supports automatic firmware updates, provides interactive security

services, and increases supervision using signal‐forwarding to the

Central Station. For wireless communication with the Control Panel,

the 900MHz Transceiver Module (2GIG‐XCVR) must be installed in the

panel. For Internet access, the Go!Bridge must be connected to the

local network router using an Ethernet cable (not provided).

Box Contents

Verify that the package includes the following:

• 1—Go!Bridge

• 1—5VDC USB Mini‐B Power Supply

• 1—Stand

• 1—Power Supply

• 1—Plastic Power Supply Bracket with Adhesive Backing 

and Zip Tie

• 2—Wall Socket Screws for Power Supply Bracket

Requirements

Before you install, program, and test the Go!Bridge, ensure the control

panel being paired with the Go!Bridge meets these requirements:

• Firmware Version 1.12 (or higher)

• 2GIG‐XCVR 900 MHz Transceiver

IMPORTANT:

For compliance with UL 1023: Household Burglar‐

Alarm System Units, the Go!Bridge must be installed in the

same room as the Internet modem or router.

NOTE:

To protect data sent via the local wireless network, it is

recommended that you install the Go!Bridge on a local

network where either WPA (Wi‐Fi Protected Access) or WPA2

(Wi‐Fi Protected Access II) encryption is already enabled.

After installing, programming, and testing the Go!Bridge, you will need

to register a new customer with the third‐party monitoring service.

See Registration on page 3.

Figure 1 Go!Bridge Front View—LED Indicators and Learn Button

A Network LED

B 900 MHz LED

C Learn Button

Powering ON the Go!Bridge

Use these steps to power ON the Go!Bridge:

Attach the power supply to the bracket (provided) as follows:

Insert the power supply into the enclosure on the plastic

bracket. See C in the figure below.

Secure the power supply to the retaining bracket by threading

a zip tie through the bracket's slots. See D in the figure below.

Affix the bracket to the wall outlet with the adhesive backing.

Then secure it to the outlet with the two (2) screws (provided).

NOTE: Always use the provided power supply bracket in the United

States (and other countries where it is required). Canada does not

require the power supply retaining bracket.

Figure 2 Power Supply and Bracket

A 110V Wall Outlet

AC Power Supply Bracket

AC Power Supply

D Zip Tie

Connect the Go!Bridge to the power source.

Do not connect an Ethernet cable to the Go!Bridge at this

NOTE:

time. You will connect the cable when completing the steps in

Programming the Go!Bridge into the Control Panel.

(Optional) Place the stand (provided) on a counter, desktop, or

other flat surface. Set the Go!Bridge in the stand.

Verify that the two (2) LEDs on the Go!Bridge illuminate in RED.

See Figure 1 Go!Bridge Front View—LED Indicators and Learn

Button.