8STREME XT3 Buku Petunjuk - Halaman 5

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pembersih Kolam Renang 8STREME XT3. 8STREME XT3 9 halaman. Above ground automatic swimming pool cleaner

Halaman Cetak

4.10 For optimal performance, place your robot

in the pool at the furthest possible location

from the power source.

This is the correct length of the cable so

��,,: _

:::;,

that the robot can reach all of your pool.

\�

, - .. � -- __ :-:_ , =,;})

,,,

->��___I-:---"'"-

Limit the length of cable in the pool to the

bare minimum for proper swivel

operation. Tie up the excess cable near

the power supply using the supplied

reusable cable ties supplied with the

cable.

�

·j

�

-�

�

">�- .

-c>

. ·-- -�

- " Z.

= �

✓

�-��, -,�7=t:.�:Y

==-----

-<-=

Page8

4.11 To turn off your robot, press the switch on the

power supply to the OFF Position

4.12 Do not remove your robot out of water

immediately after the end of its cleaning

cycle so as not to cause a temperature

shock.

4.13 When the cleaner is no longer used for an

extended period, store your robot indoors.

05 Indicator lights I LED

MEANING I DIAGNOSIS

INDICATOR

LIGHT/LED

Plug the power supply into a protected AC voltage supply

outlet. Switch the button to the ON position. The blue

light will come on and stay solid blue. If it does not light,

check the supply socket for power. If the blue light blinks,

or does not come on the Power supply is defective and must

be replaced.

"No-Twist" Floating Swivel

This blue light turns on when the floating cord between the

transformer and the No-Twist float with swivel union is

properly connected and you have turned on the robot. It

indicates that power is reaching the float. If the light does

not come on, check the connections .

This green light only lights up when the robot pump is

running. This green light does not light up when the pool

robot has completed its cleaning cycle or during certain

phases of the device's operation (e.g. during a stop before a

change of direction ).

When the "No-Twist" float with rotating swivel is connected

to the transformer and you have started the robot, this small

red light indicates that the current is coming out of the float.

You must have both this red light and the blue light (C) on the

float. If you have the blue light on the float but not the red

light, then it is likely that you wil I need to replace the float.

Page9