Galanz RFFK002B Panduan Instruksi Pengguna - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Instruksi Pengguna untuk Kulkas Galanz RFFK002B. Galanz RFFK002B 6 halaman.
Halaman Cetak
①.Pry the bolt on the thermostat
away from the lamp shade about
2 mm with a suitable tool.
③.Take out the lamp shade along
the direction of the arrow.
DEFROST
Heavy frost will influence the refrigerating of the appliance and increase the
energy consumption. Defrosting is therefore needed as the frost can reach a
thickness of 5mm.
For manual defrost: take all the food out of the compartments; remove the
drawers and shelves; unplug the electronic power cord;
Open the doors and wait for the thaw; wipe up water with a dry cloth.
Do not use any additional mechanical or electrical methods
to accelerate the defrosting process
DISCONNECTING THE APPLIANCE
After a power failure, even during the summer, the refrigerator can store food
normally for several hours.
1. Discontinuation during power failure. After power failure, do not put additional
food in the appliance and reduce the frequency of door openings. Put several
ice cubes in a container and place in the top of the fridge if the power failure
was anticipated.
2. Discontinuation during vacation. If the appliance is being left for a short
period, please consider any foods that may go off during this period and
dispose of accordingly. Ensure the doors are tightly closed before leaving. If
the appliance is being left for an extended period, please remove all food and
turn off the power. Once defrosted please clean up the liner, wipe dry and
leave the door open until return.
3. Stop using
If the refrigerator is not going to be used for a long time, please unplug,
cleanup, and leave the door open to get rid of unpleasant odours.
Please minimize powering down the appliance as this can affect
the product life. After unplugging the power, please leave at least
Attention
5 minutes beforere connecting.
6
②.Rotote the lamp
shade outwards.
④.Unscrew the bulb.
USER NOTIFICATIONS
1. Do not splash water on the refrigerator, as it will cause oxidation and
malfunction. Electronic component such as the on/off button should be wiped dry.
2. The following cleaning agents should not be used as they may damage the
painted cover and plastic: Soap powder, abrasive cleaning powder, alkali
cleansers, chemical cloth, thinner, alcohol, acid, petroleum products, hot water.
3. Any spillages, splashes or smears on the internal plastic components can
cause damage if not wiped clean.
4. Please check the points below after maintenance:
(1) Is there any damage or loss of the electronic wire?
(2) Can the plug be put into the socket reliably and smoothly?
(3 ) Is the plug heating abnormally?
Please remove the door gaskets before disposing of this
Warning
appliance. Disposal must be carried out in line with local authority
requirements.
TROUBLESHOOTING TIPS
During normal use, please do not interrupt the power as this could affect the life
of the appliance. If the units do need to be turned off, please allow at least 5
minutes before turning back on
1. The refrigerator does not work
It may not be connected to the power supply (plug, power cut or fuse); Voltage is
too low.
2. The refrigerator does not work efficiently as expected It maybe caused by
heavy frost, a warm temperature setting, or frequent door operation.
3. It makes unusual noise It may be caused by an imbalance or loose location
of the appliance, or by resonation between the appliance and other objects.
4. The compress or keeps working for a long period. The location environment
maybe too hot. The doors maybe opened too frequently
or left open. The temperature control knob set (4-7) may increase the working
time of the compressor.
5. Foul odour present
Food with strong odours should be packed tightly before being put inside the
appliance.
6. Water leaks from the bottom of the refrigerator. The drain tube is jammed.
Please use a proper tool to unblock it.
7. Heavy frost occurs on the rear of the appliance. Putting humidor hot food
into the appliance may cause this problem. Or it maybe caused by high humidity.
7