Galanz W60B1A101M-A Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin pencuci piring Galanz W60B1A101M-A. Galanz W60B1A101M-A 14 halaman.

Halaman Cetak

6. Starting a Washing Programme

Wash cycle table

Cycle Selection

Program

Information

For the heaviest soiled loads,

such as pots, pans, casserole

dishes and dishes that have

been sitting with dried food

Intensive

on them for a while.

For normally soiled loads,

Eco

such as pots, plates, glasses

(*E 50242)

and lightly soiled pans.

(Standard

standard daily cycle.

Programme)

Is optimised according to the

soiled loads,such as

Auto

pots,pans,utensils and

cutlery,with the aid of sensors

For lightly and normally soiled

plates and pans for every day.

60 min

A shorter wash for lightly

soiled loads that do not

Rapid

need drying.

To rinse dishes that you

plan to wash later that day

Pre-Rinse

50242:this program is the test cycle.

The information for comparability test in accordance with EN 50242,as follows:

Capacity:14 settings

- Position of upper basket :Low position

- Rinse aid setting:5(or 4 for four setting dispenser)

Turning on the Appliance

Starting a wash cycle...

Draw out the lower and upper basket, load the dishes and

1. push them back. It is recommended to load the lower basket first, then the upper one (see the

section entitled "Loading the Dishwasher"). Pour in the detergent (see the section entitled "Salt,

Detergent and Rinse Aid").

2. Insert the plug into the socket. The power supply is 220-240V AC 50 Hz, the specification of the

socket is 12 A 250 VAC.50 Hz.

Make sure that the water supply is turned on to full pressure. Close the door, press the "Power"

button, press the "program". button to select a desired "Wash cycle". (See the section entitled "Wash

Running

Energy

Description

Detergent

Time

Pre/main

(kWh)

of Cycle

(min)

Pre-wash

Main wash(60℃)

Rinse1

5/30g

169

1.500

Rinse2

(or 3 in 1)

Hot rinse

Drying

Pre-wash

5/30g

Main wash(46℃)

178

0.930

(or 3 in 1)

Hot rinse

Drying

Pre-wash

Main wash

0.600

5/25g

Rinse

101-221

-1.700

Hot rinse

Drying

Hot rinse1

Hot rinse2

5/20g

1.000

Hot rinse(60℃)

Drying

Main wash(40℃)

15g

0.550

Hot rinse

Pre-wash

0.010

Cycle Table".)

With a little force to ensure the door is properly closed.

NOTE:

A click could be heard when the door is closed perfectly.

When the washing is over, you can shut off the switch by pressing "Power" button.

Switching on

Water

1. Open the tap, if it is closed.

(L)

2. Close the door.

3. Make sure the spray arms are not obstructed.

4. Switch the dishwasher on using the "Start/Pause" button.

Select a programme

Choose your programme according to the type of load and how dirty it is.

The different programmes and their uses are described in the programme chart later on in this

booklet. Use the programme selector to select the expected programme .

Change the Programme.

Premise: A cycle that is underway can only be modified if it has only been running for a short time.

Otherwise, the detergent may have already been released, and the appliance may have already

drained the wash water. If this is the case, the detergent dispenser must be refilled (see the section

entitled " Fill in the Detergent " ).

8-18

1.Press " Power " button or reset button for 3 second to cancel the programme.

2.Turn on it again and you can change the programme to the desired cycle setting (see the section

entitled "Starting a wash cycle. . . " ) or press programme button while you press "reset " button .

NOTE: If you open the door when the washing cycle underway, the appliance will pause and emit

11.5

warning signals, the digital display show "E1" and flash. When you close the door, the machine will

keep on working after 10 seconds.

Forget to Add Dish

A forgotten dish can be added any time before the detergent cup opens.

1 Open the door a little to stop the washing.

2 After the spray arms stop working, you can open the door completely.

3 Add forgotten dishes.

4 Close the door, the dishwasher will work after ten seconds.

WARNING!

It is dangerous to open the door when washing, because the hot water may scald you.

Switch Off the Dishwasher

The digital display appears "---" and the buzzer rings 6 times, only in this case the programme has

ended.

1.Switch off the dishwasher by pressing the "Power " button.

2.Turn off the water tap!

Open the door carefully. Hot steam may escape when the door is opened!

■Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around

15 minutes before removing from the appliance.

■Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In

this way they will be cooler and the drying will be improved.

Unloading the dishwasher

It is normal that the dishwasher is wet inside.

Empty the lower basket first and then the upper one. This will avoid water dripping from the upper

basket onto the dishes in the lower one.