Autonics PA10-V Panduan Memulai Cepat - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Pengontrol Autonics PA10-V. Autonics PA10-V 8 halaman. Multifunctional sensor controller
Juga untuk Autonics PA10-V: Buku Petunjuk (2 halaman)
Halaman Cetak
PA10 Series
Application Of Derivative Operation
Sensing labels of glass bottles
IN2
(Sensor for
synchronization)
BEN300-DDT
(Sensor for detecting
BEN300-DDT
● Operation
When IN2 is ON after IN1 is ON, OUT will not operate. But if there is no label on bottle, OUT will operate with IN2 is ON
only. OUT will be returned after setting time.
Note)Please install the sensor (IN1) to be operated first.
Factory Default For S/W
●PA10-U:
MODE1 ON-DELAY
Proper Usage
Load connections
It is important to protect from surge or noise by installing
a surge absorber across inductive loads (motor, solenoid,
etc).
In case the load is a DC relay, please install a diode across
relay as shown below.
(Be careful of polarity.)
PA10-U
※ Surge absorber
NO
Resistance:22Ω, Condenser:0.1㎌,
Voltage:630V
NC
COM
Relay output
(Fig. 1) When it is relay output
O-8
Brown
Blue
Brown
Blue
Black
IN1
the target)
SOURCE
100-240VAC
50/60Hz
Output (OUT)
●PA10-V: NORM
●PA10-VP: NORM
SOURCE
※
O.C.
Black
OUT1
IN1 (Sensor for
detecting the target)
IN2 (Sensor for
synchronization)
O.C.
Derivative operation
OUT2
OUT (3-4)
O.C. OUT1
(12-10)
O.C. OUT2
(16-14)
※ T: Setting time
(Refer to O-5 for the range of setting time.)
●PA10-W: NORM
●PA10-WP: NORM
PA10-U
※ Max. reverse voltage is at least 3 times over
than load voltage.
O.C. OUT
Current capacity: 1A
(Fig. 2)When it is NPN open collector
Input signal line
● Please make the cable line short from input sensor to
this controller.
● Do not put input signal line with other power cable in the
same conduit.
● When need to extend the input signal line, please use
shielded cable.
No Label
Label
ON
OFF
ON
OFF
ON
OFF
ON
OFF
OFF
ON
OFF
ON
+
DC POWER
※
-
T