dBTechnologies B-Hype Mobile Panduan Pengguna - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembicara dBTechnologies B-Hype Mobile. dBTechnologies B-Hype Mobile 4 halaman. Bi-amp battery powered portable system active speakers
Halaman Cetak
www.dbtechnologies.com
7) MEDIA PLAYER SECTION
In this section you can find:
SD Audio Input:
USB Audio Input:
Controls buttons
a) Audio reproduction from USB flash drive / SD
CARD
1. Turn on the B-HYPE MOBILE (see chapter 4 for
further information), and check that the MASTER
volume and the Bluetooth
/USB/SD one is on a
®
medium/low level (see chapter 5).
2. Insert the correct device (a USB flash drive or SD
CARD). Please note that only MP3, WAV and
WMA files can be read and that the player can
read only one media source at a time.
3. Push
the
button for a few seconds.
Once the reader is on, you can select the audio
source by shortly pressing the same button.
4. Push the buttons
to play/pause, search through the folders,
repeat/change the equalization, rewind, fast
forward a track respectively.
5. Adjust the MASTER and Bluetooth
/USB/SD
®
volumes.
b) Audio reproduction from Bluetooth
device
®
B HYPE MOBILE
info@dbtechnologies aeb.com
1. Turn on the B-HYPE MOBILE (see chapter 4 for
further information), and check that the MASTER
volume and the Bluetooth
/USB/SD one is on a
®
medium/low level (see chapter 5).
2. Push
the
button for a few seconds to
turn on the player.
3. Once the reader is on, you can select the audio
source by shortly pressing the same button.
4. Enable Bluetooth
transmission on your device
®
and check that its "visibility mode" is enabled.
5. Once the communication is established, the
name of your device is displayed on the screen.
Adjust the source volume, and the MASTER and
Bluetooth
/USB/SD ones.
®
8) THE HT-BHM CHARGER
"RECHARGE" mode allows the user to charge not only
the internal LI-Ion battery, but also the HT-BHM
transmitter. HT-BHM can be charged also in "ON"
mode, while B-HYPE MOBILE is turned on.
In order to correctly charge the transmitter:
1. Use the correct HT-BHM batteries (Ni-MH AA type
only)
2. Insert properly the handheld transmitter in the
charger on the rear panel
3. Turn on the B-HYPE MOBILE ("Power" LED green)
or select the "RECHARGE" mode ("Charge" LED
red).
4. The Led of HT-BHM charger can be:
RED – the batteries are charging
GREEN – the batteries are fully charged
FLASHING RED – the batteries in the
transmitter are not of the correct type
6
cod. 420120272Q REV.1.2
www.dbtechnologies.com
b) Place the batteries (not included)
Please note that for the correct use of the integrated
charger of B-HYPE MOBILE, only Ni-MH batteries must
be used with the HT-BHM.
3) A CONTROLS OVERVIEW
The top and rear panel can be divided in main sections:
MEDIA PLAYER SECTION
CONNECTIONS AND CONTROL SECTION
RECEIVER MODULE R-BHM
BATTERY HOLDER
HT-BHM CHARGER
MAINS SECTION
In the following chapters these sections are presented
and they are recalled with reference to this scheme.
B HYPE MOBILE
info@dbtechnologies aeb.com
3
cod. 420120272Q REV.1.2