909 DWL850 Buku Petunjuk - Halaman 5
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Listrik 909 DWL850. 909 DWL850 12 halaman. 600w dowel joiner
Halaman Cetak4) Power tool use and care
a) Do not force the power tool. Use the correct power
tool for your application.
do the job better and safer at the rate for which it was
designed.
b) Do not use the power tool if the switch does not turn
it on and off.
Any power tool that cannot be controlled
with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or
the battery pack from the power tool before making
any adjustments, changing accessories, or storing
power tools.
Such preventive safety measures reduce
the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tool's
operation. If damaged, have the power tool repaired
before use.
Many accidents are caused by poorly
maintained power tools.
f ) Keep cutting tools sharp and clean.
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to be
performed.
Use of the power tool for operations different
from those intended could result in a hazardous situation.
h) This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge,
unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
The correct power tool will
Properly
i) Children should be supervised to ensure that they do
not play with the appliance.
5) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
will ensure that the safety of the power tool is maintained.
Additional safety rules for dowelling
machines
Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
•
Fully unwind cable drum extensions to avoid potential
overheating.
•
When an extension cable is required, you must ensure it
has the right ampere rating for your power tool and is in a
safe electrical condition.
•
Ensure your mains supply voltage is the same as your
tool rating plate voltage.
•
Your tool is double insulated for additional protection
against a possible electrical insulation failure within the
tool.
•
Always check walls, floors and ceilings to avoid hidden
power cables and pipes.
•
After long working periods external metal parts and
accessories could be hot.
•
Do not force the tool. Let it work at a reasonable speed.
Overloading will occur if too much pressure is applied
and the motor slows resulting in inefficient operation and
possible damage to the motor.
•
Never start the machine with the drill bit touching the
work piece.
•
Never set down the tool until the motor has come to a
complete standstill.
•
Keep hands well away from the cutting area. Do not
reach under the work piece during operation. Do not
move or remove the work piece while operating this tool.
5
This