GALAXIS SHOWTECHNIK PYROTEC PFS Pocket Panduan Pengguna - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pemancar GALAXIS SHOWTECHNIK PYROTEC PFS Pocket. GALAXIS SHOWTECHNIK PYROTEC PFS Pocket 17 halaman.

Halaman Cetak

- 11 -

9. Switching the firing mode on and off (Arming the PFS Pocket)

To activate the firing mode, press the "Arm" button. After successfully switching on the firing mode, the

device will confirm this with an acoustic signal and the LED above the button "Arm" is illuminated

constantly in red.

To switch off the firing mode, press the "Arm" button again. The PFS Pocket reverts back into normal

mode, and the red LED will no longer be illuminated.

If the deadman function is enabled, the red LED "DM" blinks while the firing mode is activated. This

tells you that ignition commands can only be sent when the button "DM" is pressed.

When switching off the firing mode at the PFS Pocket the device sends a signal to all receivers.

Currently active stepping sequences and all probably active outputs are terminated on devices of the

Advanced series. Devices of the Profi series show a different reaction depending on the programmed

step delays. Further information is given in the user manuals of these devices. For the correct function

of this command it is necessary that the receiving device is within range and that the command is

being received flawlessly.

10. Switching on and off the deadman function

Deadman means that this button (DM) must be held depressed at the same time as the firing channel

button is depressed, in order to transmit an ignition signal. The deadman button will avoid unwanted or

accidental pressing of firing buttons and subsequent unwanted ignitions.

To switch this function on or off, please make sure the device is in normal mode. Remove the battery

cover and activate the magnetic sensor "DM" with a magnetic pen.

If the LED adjacent to the magnetic sensor lights red, the deadman function is activated.

After this replace the battery cover.

As an indication that the deadman function is activated, the LED "DM" flashes when the firing mode is

activated. This informs the user that ignition commands can only be sent if the deadman button is

pressed simultaneously to the Channel Firing button selection.

11. Transmitting firing commands

First activate the Firing Mode with the button "Arm" when the PFS Pocket is in normal mode. Press (if

necessary) the button "DM" (Deadman) and activate the specific firing button 1 to 6. The different firing

buttons fire the particular firing channel. Firing button 1 fires channel 1, firing button 2 fires channel 2,

etc.

The Fire LED on the top of the front panel flashes for a short time in red when a firing command

transmitted.