Autonics TC4S Manual - Halaman 5

Jelajahi secara online atau unduh pdf Manual untuk Pengontrol Suhu Autonics TC4S. Autonics TC4S 14 halaman. Touch switch type temperature controller
Juga untuk Autonics TC4S: Manual (14 halaman), Manual (2 halaman), Buku Petunjuk (2 halaman), Panduan Memulai Cepat (9 halaman), Panduan Memulai Cepat (10 halaman)

Halaman Cetak
Autonics TC4S Manual
TC Series
Unit Description
1
3
2
6
1. Present temperature (PV) display
RUN mode: Present temperature (PV) display.
Parameter setting mode: Parameter or parameter
setting value display.
2. Deviation indicator, Auto-tuning indicator
It shows current temperature (PV) deviation based on set
temperature (SV) by LED.
No.
PV deviation temp.
1
Over 2℃
2
Below ±2℃
3
Under -2℃
The deviation indicators ( ,
when operating auto tuning.
3. Set temperature (SV) indicator
Press any front key once to check or change current set
temperature (SV), the set temperature (SV) indicator is
ON and preset set value is flashed.
4. Temperature unit(℃/℉) indicator
It shows current temperature unit.
SV Setting
※ In case of changing set temperature from 210℃ to 250℃.
Press any key among
④ Check SV
Parameter Reset
Reset all parameters as factory default. Hold the front
Select 'YES' and all parameters are reset as factory default. Select 'NO' and previous settings are maintained. If setting parameter
lock [LOC] or processing auto-tuning, parameter reset is unavailable.
H-58
4
5
8
7
Deviation display
indicator ON
indicator ON
indicator ON
,
) flash by every 1 sec.
① RUN mode (display a current temperature)
,
,
,
② Set value change
mode change set
value by
,
,
keys.
1
2
3
5. Control/alarm output indicator
OUT: It will turn ON when control output (Main Control
Output) is ON.
※ In case of CYCLE/PHASE control of SSR drive output,
it will turn ON when MV is over 3.0%. (only for AC
voltage type)
AL1/AL2: It will light up when alarm output Alarm 1/
Alarm 2 are on.
6.
key
Used when entering into parameter group, returning
to RUN mode, moving parameter, and saving setting
values.
7. Adjustment
Used when entering into set value change mode, digit
moving and digit up/down.
8. FUNCTION key
Press
+
keys for 3 sec. to operate function (RUN/
STOP, alarm output cancel, auto-tuning) set in inner
parameter [ DI-K ].
※ Press
+
operation to move digit.
③ Finish the setup.
+ +
keys for 5 sec., to enter parameter reset [INIT] parameter.
6
5
4
keys at the same time in set value
7, 8