Hifonics Brutus BRZ 1200.1D Panduan Pengguna - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penguat Mobil Hifonics Brutus BRZ 1200.1D. Hifonics Brutus BRZ 1200.1D 15 halaman.
Juga untuk Hifonics Brutus BRZ 1200.1D: Panduan Pengguna (15 halaman)
Halaman Cetak
BRZ1700.1D MONO AMPLIFIER APPLICATIONS
Basic application
Interconnect cable checklist:
- Connect the line inputs to a Radio/CD RCA outputs or line output of the
full range primary amplifier with good quality RCA cables. A "Y" adapter
may be needed as shown in the diagram.
- Use at least 16 gauge speaker wiring. These amplifiers have dual
speaker terminals, simplifying the hookup of multiple speakers. The 2
positives are the same and the 2 negatives are the same.
Crossover frequency control checklist:
- LOW PASS: 35Hz to 250Hz
- SUBSONIC:15 Hz to 35 Hz
- BASS EQ: 0 to 10dB
- PHASE: 0 to 180 degrees
Level control checklist:
- Refer to the section "Setting up systems after installation for best
performance"
*
DESIGNATED
MONO LINE INPUT
B O O S T
H F R - 3
M I N
M A X X
Dual Subwoofer Application
*
DESIGNATED
MONO LINE INPUT
B O O S T
H F R -3 M INM A X X
Minimum final loudspeaker impedance:
- 1 ohm.
FULL RANGE
STEREO LINE INPUT
NOT USED
Note: You can use the Radio/CD designated mono line output
*
or a full range stereo line output. For full range stereo line output,
you will need an optional "Y-Adaptor" as shown
Y-ADAPTOR
MONO
SUBWOOFER
1-OHM MINIMUM
REMOTE TURN-ON
CHASSIS GROUND
TO BATTERY +12v
VIA FUSE
PARALLEL MONO
SUBWOOFERS
2-OHMS SVC EACH MINIMUM,
or 4-OHMS DVC EACH MINIMUM
MONO
SUBWOOFERS
REMOTE TURN-ON
CHASSIS GROUND
TO BATTERY +12v
VIA FUSE
4