ADENDORFF MAC AFRIC SDRILC-005 Petunjuk Pengoperasian Asli - Halaman 7
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian Asli untuk Obeng Daya ADENDORFF MAC AFRIC SDRILC-005. ADENDORFF MAC AFRIC SDRILC-005 14 halaman. Cordless brushless driver/hammer drill
Halaman Cetak
FFCL18-01
Model
FFCL18-03
Input Voltage (AC)
220-240V
Charging Current
Input Power Frequency
Applicable Battery Cartridge Voltage
(DC)
2.0Ah
Full Charging Time
4.0Ah
Insulation Grade
2. Charging Operation
1.
Plug the battery charger into the proper AC power source. The charging indicator light
will flicker in green color and the charger operates in standby mode.
2. Insert the battery pack fully into the battery charger and the charger starts charging.
The battery charger can detect some sort of failure caused by the battery and indicates by the
statuses of the red and green indicator lights.
When a failure occurs, remove the battery
and then insert it into the charger again. If the
failure continues, change with a new battery.
If the new battery can be charged, then the
old battery maybe damaged. If the charging
indicator lights indicate same failure as
before while changing with a new battery,
then the charger maybe damaged, take the
charger
to
be
repaired
by
qualified
serviceman. (Fig. 5)
The following chart lists the relations between the statuses of charging and charging
indicator lights.
SCHARG-001
SCHARG-001
FFCL18-04
(FFCL18-05)
110-240V
220-240
3.0A
2.0A
50-60Hz
14.4-18V
≈45min
≈70min
≈90min
≈135min
Double Insulation
Descriptions of
Icons
Charging Status
Plug the charger into
a proper outlet
During charging
Charge complete
Abnormity occurs on
the battery
The temperature of
the battery is under
0℃ or higher than
50℃
Installing or Removing Tool
The tool here includes driver bit, drill bit, etc, which differs from the concept of power tools
or machines.
CAUTION:
Before operation, always set the reversing
switch lever in the central position and
remove the battery. Mustn't press switch
trigger.
1. Installing instrument
Hold the ring and turn the sleeve
counterclockwise to open the chuck jaws.
Place the bit in the chuck as far as it will go.
Hold the ring firmly and turn the sleeve
clockwise to tighten the chuck (view backwards). (Fig. 6)
Icons of Charging
Descriptions of
Indicator Lights
Charging Indicator
Green
Red
Lights
Light
Light
Green light flickers, red
light extinguished
Green light extinguished,
red light keeps
flickering steadily
Green light keeps up
steadily, red light
extinguished
Green and red light
flicker alternately
Green light extinguished,
red light flickers