Galaxy DX−33HML Panduan Pemilik - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Transceiver Galaxy DX−33HML. Galaxy DX−33HML 8 halaman. Full channel am/fm mobile transceiver
Halaman Cetak
Fig. 2 Microphone plug wiring
4. Remove the retaining screw
5. Unscrew the housing from the pin receptacle body
6. Loosen the two cable clamp retainer screws.
7. Feed the microphone cable through the housing, knurled ring and washer as
shown Fig. 2.
8. The wires must now be soldered to the pins as indicated in the above wiring
tables. If a vise or clamping tool is available it should be used to hold the pin
receptacle body during the soldering operation, so that both hands are free to
perform the soldering. If a vise or clamping tool is not available, the pin
receptacle body can be held in a stationary position by inserting it into the
microphone jack of the front panel. The numbers of the pins of the microphone
plug are shown in Fig. 3, as viewed from the back of the plug. Before
soldering the wire to the pins, pre-tin the wire receptacle of each pin of the
plug.
- 13 -
Specifications
GENERAL
Frequency Range
Frequency Control
Frequency Tolerance
Frequency Stability
Operating Temperature
Range
Microphone
Input Voltage
Size
Weight
Antenna Connector
Meter
TRANSMITTER
Power output
Modulation
Spurious Emissions
Frequency Response
Output Impedance
Output Indicators
28.065 to 28.505 MHz
Phase Lock Loop (PLL) synthesizer.
0.005%
0.001%
-30 °C to +50 °C.
Plug-in dynamic; with push-to-talk switch and
coiled cord.
13.8V DC nominal, 15.9V max, 11.7V min.
(Positive or negative ground).
Transmit: AM full mod., 2.2A.
Receiver: Squelched, 0.3A.
Maximum Audio output, 0.7A.
2-3/8" (H) x 7-7/8" (W) x 9-1/4" (D).
5 Ibs.
UHF, SO239
Illuminated; indicates relative output power,
received signal strength.
AM/FM, High-7 watts
Low-3.5 watts
High-and low-level Class B, Amplitude
Modulation:
AM.
Variable
Frequency Modulation: FM.
60 dB
AM and FM: 450 to 2500 Hz.
50 ohms, unbalanced
Meter shows relative RF output power and
SWR. Transmit LED glows red when
transmitter is in operation.
- 2 -
capacitance