909 LS15CS Buku Petunjuk - Halaman 10

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Melihat 909 LS15CS. 909 LS15CS 16 halaman. 15 amp dual laser circular saw with magnesium

Halaman Cetak

Note.

Always make a trial cut in a scrap piece of material

along a guideline to determine how much you should offset

the blade from the guideline to make an accurate cut.

Switching on and off

1. Connect the plug to the power supply.

2. Depress the lock-off button (5) (Fig. F) and squeeze the

trigger switch (4) (Fig. G).

3. The blade will take approximately 2 seconds to reach

full speed.

4. When you release the trigger, the machine turns off

and the lock-off button re-engages to prevent

accidental operation.

CAUTION.

Ensure you have a firm grip on the handles with

both hands at start up as the tool will produce kickback.

Making a cut

1. Mark the line of cut on the work piece.

2. Adjust the depth of cut and bevel angle as required.

3. When making 90° cross or rip

cuts, align your line of cut with

the outer blade guide notch on

the base of the saw (Fig. H).

4. When making 45° bevel cuts,

align your line of cut with the

inner blade guide notch on the

base of the saw.

5. Rest the front edge of the base

on the work piece (Fig. I).

6. Start the motor by depressing

Note.

full speed (approximately

2 seconds) before you begin to

cut into the work piece.

7. Slowly push the saw forward

8. When making a cut always

9. After completing your cut, release the trigger switch

Note.

cut in scrap material along the guideline to determine how

much, if any, the guideline must be offset to get an

accurate cut.

Making a pocket cut

1. Adjust the depth of cut as

Blade guide

2. Adjust the bevel setting to 0°.

notch

3. Raise the lower blade guard

Blade guide notch

the lock-off button (5) and

squeezing the trigger

switch (4).

Always let the blade reach

using both hands (Fig. J).

use steady, even pressure.

Forcing the saw causes rough

cuts and could shorten the life

of the saw or cause kickback.

Allow the blade and the saw to

do the work.

and allow the blade to come to a complete stop.

Do not remove the saw from the work piece while the

blade is moving.

Since blade thickness varies, always make a trial

required.

lever (13) to expose the saw

blade and firmly rest the

front of the base flat against

the work piece with the rear

handle raised so the blade does not

touch the work piece (Fig. K).