909 LS15CS Buku Petunjuk - Halaman 4
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Melihat 909 LS15CS. 909 LS15CS 16 halaman. 15 amp dual laser circular saw with magnesium
Halaman Cetak
General safety rules
WARNING
Read and understand all instructions. Failure
to follow all instructions listed below, may result in electric
shock, fire and/or serious personal injury.
Save these instructions
Work Area
1. Keep your work area clean and well lit.
benches and dark areas invite accidents.
2. Do not operate power tools in explosive atmospheres,
such as in the presence of flammable liquids, gases,
or dust.
Power tools create sparks which may ignite the
dust or fumes.
3. Keep bystanders, children, and visitors away while
operating a power tool.
Distractions can cause you to
lose control.
Electrical Safety
1. Double Insulated tools are equipped with a polarized
plug (one blade is wider than the other.)
fit in a polarized outlet only one way. If the plug does not
fit fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install a polarized outlet.
Do not change the plug in any way. Double Insulation
eliminates the need for the three wire grounded power
cord and grounded power supply system.
2. Avoid body contact with grounded surfaces such as
pipes, radiators, ranges and refrigerators.
increased risk of electric shock if your body is grounded.
3. Don't expose power tools to rain or wet conditions.
Water entering a power tool will increase the risk of
electric shock.
4. Handle the cord carefully.
the tools or pull the plug from an outlet. Keep cord away
from heat, oil, sharp edges or moving parts. Replace
damaged cords immediately. Damaged cords increase
the risk of electric shock.
Cluttered
This plug will
There is an
Never use the cord to carry
5. When operating a power tool outside, use an
outdoor extension cord marked "W-A" or "W".
These cords are rated for outdoor use and reduce
the risk of electric shock.
Personal Safety
1. Stay alert, watch what you are doing and use
common sense when operating a power tool.
Do not use tools when tired or under the influence of
drugs, alcohol, or medication. A moment of inattention
while operating power tools may result in serious
personal injury.
2. Dress properly.
Do not wear loose clothing or jewelry.
Contain long hair. Keep your hair, clothing, and gloves
away from moving parts. Loose clothes, jewelry or long
hair can be caught in moving parts.
3. Avoid accidental starting.
before plugging in. Carrying tools with your finger on
the switch or plugging in tools that have the switch on
invites accidents.
4. Remove adjusting keys or wrenches before turning
the tool on.
A wrench or a key that is left attached to a
rotating part of the tool may result in personal injury.
5. Do not overreach.
Keep proper footing and balance
at all times. Proper footing and balance enables better
control of the tool in unexpected situations.
6. Use safety equipment.
Dust mask, non-skid safety shoes, hard hat or hearing
protection must be used for appropriate conditions.
Tool Use and Care
1. Use clamps or other practical way to secure and
support the workpiece to a stable platform.
the work by hand or against your body is unstable and
may lead to loss of control.
2. Do not force tool.
Use the correct tool for your
application. The correct tool will do the job better and
safer at the rate in which it is designed.
4
Be sure switch is off
Always wear eye protection.
Holding