Galaxy 790.60301 Panduan Penggunaan & Perawatan - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Penggunaan & Perawatan untuk Rentang Galaxy 790.60301. Galaxy 790.60301 14 halaman.

Halaman Cetak
Care & Cleaning
Fig 1
or
use
a Nail
Fig. 2
about 45
Hinge
Removing
and Replacing
the Oven
Door
The door is heavy For safe, temporary storage, Iay the door fiat
with the inside of the door facing down.
To Remove Oven Door:
1.
Open oven door completely (horizontal with floor _See Fig. 1).
2.
Remove 2 screws located on the inside of the oven door liner (See A Fig. 2)
3.
Insert the 2 screws into the door hinge holes located on the side of the hinge arm, one
into each hinge (See B Fig. 2).
4.
Close oven door until the doorstops,
(Do not force the door to close any further). The
placement of these screws should keep door open in about a 45 degree position.
5.
Grasp oven door firmlyon both sides and slide door up and offhinges at the same angle.
(See Fig. 3)
6.
To clean oven door, follow the instructions in the Care & Cleaning
table (page 9).
To Replace Oven Door:
1.
Be sure the hinge arms remain at the45 degree angle position
Besure the screws are
still locking the hinge arms from moving, if the screws fall out of the hinge holes, the
hinge(s) may snap back against the oven frame and could pinch fingers or chip the
porcelain finish on the oven front frame.
2.
Holddooratthesidesnearthetopwhilerestingthelowerfrontofdooronyourknee.
rrl
Insert the door channels at the bottom of door over the door hinges, (See Fig. 3).
Z
3.
Allowthedoortoslidedownintothedoorhingesevenlyatthesame45degreeangle.
G)
I--
The hinge arms should be inserted into the bottom cerners as far as they can go.
,..
4.
Open door completely (horizontal with floor) and remove both screws from holes in
door hinges.
"1"
5.
Reinstall the 2 screws into the door liner (See C Fig. 2).
6.
If the door is not in alignment with the oven frame, remove door and repeat the above
steps.
Fig. 3
11