909 PS26W Buku Petunjuk - Halaman 13

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Melihat 909 PS26W. 909 PS26W 20 halaman. 26cc pole trimming saw

5. Check the ignition On / Off

switch is on. (I pressed

down) Pull the recoil starter

until you hear the engine

starting or trying to start.

(Under full choke it may only

run for 1 or 2 seconds).

Do Not keep trying to start

the motor or you will flood

the motor. Move the red

choke lever downwards.

Allow the motor to run and

warm up for a further 5

seconds. Then slowly move

the red choke lever down to

the run position.

6. If the petrol motor starts and

then stops, move the red

choke lever down half way

and re start. Allow the motor

to warm up for approx 20 sec

and then slowly move the

red choke lever down to the

run position.

7. Once the engine is fully

warm ensure the red choke

lever is down fully to the run

position (warm start) and pull

the throttle trigger and release.

This will release the throttle lock.

8. To engage the chain drive on the pole saw increase the

speed of the motor.

To disengage the chain drive, release pressure on the

throttle trigger (4).

To increase the speed of the chain, squeeze the safety

lever (5) first, and then squeeze the throttle trigger. To

reduce the speed of the chain, release the throttle lever to

obtain the required speed.

Warm start

When re starting the pole saw after it has been used and

the motor is hot, there is no need to engage the red choke

lever. Follow steps 4, 5 6 and 7 opposite.