2GO Active BT1 Manual - Halaman 6
Jelajahi secara online atau unduh pdf Manual untuk Headset 2GO Active BT1. 2GO Active BT1 19 halaman.
Halaman Cetak
EN User Manual
Headset Snap BT2
Bluetooth headset should be used with the compatible devices which
support Bluetooth wireless technology.This allows you to make calls and
enjoy the music streaming at any time freely. Please read this user manual
carefully before using the headset, and also read your device's user
manual regarding the Bluetooth function, and pay attention to those
important safety and maintenance information. Please keep the headset
away from children.
Status des Headsets
1 Pairing Mode
The headset can be searched, the indicator light flashes red and blue
alternately.
2 Not Connected
The headset is not connected with the device, blue light will flash twice
each 8 seconds.
3 Standby Mode
The headset is connected with the device, and no any other operations,
blue light will flash once each 6 seconds.
4 Call State
In a call state, the indicator light flashes blue once each 6 seconds.
5 Charging State
The indicator light turns red while being charged, and will turn off
automatically after being fully charged with blue light for 5 minutes.
Charging Your
Prior to using the headset for the first time, please fully charge the
battery.
Approximately 2 hours are required to fully charge the headset.
The indicator light turns red while being charged, and will turn off
automatically after being fully charged with blue light for 5 minutes.
When the battery's voltage below 3.3V, the speaker will prompt "Please
Charge" once each 30 seconds (the headset will switch off automatically
when the battery's voltage is less than 3.0V. You can hear "Power off").
Please charge the headset as above steps in time to prolong the
battery's useful life (Charging indication will be delayed for a few
minutes if the headset has not been used for a long time or the battery is
Specifications
Note 1: Check the charging device is suit to the headset.
Note 2: Use only the supplied charger to charge the headset, or
Note 3: Do not attempt to force open the built-in battery as this could
damage the headset.
Note 4: If left unused, a fully charged headset will lose its power
automatically. It is recommended to charge the headset each three months.
Note 5: Do not leave the headset in a too hot or too cold
obey the validation for this product or the maintenance
condition (best between -20℃and 60℃) which may affect the headset's
operations although it is fully charged.
Note 6: Do not dispose of the headset into a fire or water
article and could be dangerous.
Turning On The Headset
In OFF MODE, press and hold MFB for 1 second, until you hear "Power
on", the indicator light turns blue for 6 seconds, then the headset will enter
into ON MODE.