Dynapac CA280 Panduan Bengkel - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Bengkel untuk Kendaraan Utilitas Dynapac CA280. Dynapac CA280 20 halaman. Vibratory roller

Halaman Cetak
Dynapac CA280 Panduan Bengkel
- Study and understand the operating instructions before start.
- Study and understand the operating instructions before start.
- Check the machine for any serious faults.
- Check the machine for any serious faults.
- Do not operate the machine with defective instruments, warning lights or control elements.
- Do not operate the machine with defective instruments, warning lights or control elements.
- All safety devices must be in a secure position.
- All safety devices must be in a secure position.
- Do not carry loose or secure them to the machine.
- Do not carry loose or secure them to the machine.
- Keep oily and inflammable material away from the machine.
- Keep oily and inflammable material away from the machine.
- Before entering the driver's cab, check if persons or obstacles are in the way of or underneath
- Before entering the driver's cab, check if persons or obstacles are in the way of or underneath
the machine.
the machine.
- Be careful when entering the driver's cab, use the steps.
- Be careful when entering the driver's cab, use the steps.
- Adjust your seat before starting.
- Adjust your seat before starting.
- When starting, all operating levers must be in "neutral position".
- When starting, all operating levers must be in "neutral position".
- Only start the machine from the driver's seat.
- Only start the machine from the driver's seat.
- Check the indicating instruments after start to ensure that all functions are in order.
- Check the indicating instruments after start to ensure that all functions are in order.
- Do not leave the machine unattended when the engine is running.
- Do not leave the machine unattended when the engine is running.
2
3
4
Fig. Jump starting
2010-04-16

Safety regulations

Before start

Start

Jump starting

1
Turn the ignition and all power consuming equipment
off. Switch off the engine on the machine which is
providing jump start power.
First connect the jump start battery's positive terminal
(1) to the flat battery's positive terminal (2).Then
connect the jump start battery's negative terminal (3)
to, for example, a bolt (4) or the lifjting eye on the
machine with the flat battery.
Start the engine on the power providing machine. Let it
run for a while. Now try to start the other machine.
Disconnect the cables in the reverse order.
W3023EN3.pdf
Safety regulations
Do not connect the negative cable to the
Do not connect the negative cable to the
negative terminal on the dead battery. A spark
negative terminal on the dead battery. A spark
can ignite the oxy-hydrogen gas formed
can ignite the oxy-hydrogen gas formed
around the battery.
around the battery.
Check that the battery used for jump starting
Check that the battery used for jump starting
has the same voltage as the dead battery.
has the same voltage as the dead battery.
3