909 LT18V Buku Petunjuk - Halaman 18
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pemangkas 909 LT18V. 909 LT18V 20 halaman. 20v lithium ion cordless line trimmer
3. Remove the empty spool
and clean out the spool
cover.
4. Using a fully wound spool,
pass the line through the
eyelet of the spool. Fit the
spool of line into the spool
cover fully. Applying light
pressure, rotate the spool
of line until it locks
in position.
5. Replace the spool cover
ensuring the 2 clips locate
and snap in place. Check
the cover is secure.
6. Push the square button
on the spool and at the
same time, pull on the
cutting line. Extend the
line just past the cutter on
the guard.
CAUTION:
After changing
the line spool, run the
trimmer under no load for at
least a minute to make sure
that the line and the tool
are both operating correctly.
Use only the line spool
as recommended by the
manufacturer.
The replacement spool and line part number is 20VSPL.
Push
Pull line
Maintenance and cleaning
1. Store the tool, instruction manual and accessories in
a secure, dry place. In this way you will always have
the information ready to hand.
2. Keep the tool's air vents unclogged and clean at
all times.
3. Remove dust and dirt regularly. Cleaning is best done
with a rag.
4. All bearings and bushes are lubricated for life.
5. Never use caustic agents to clean plastic parts.
CAUTION:
Do not use cleaning agents to clean the plastic
parts of the tool. A mild detergent on a damp cloth is
recommended. Water must never come into contact with
the tool.
General inspection
Regularly check that all the fixing screws are tight.
They may vibrate loose over time.
Storage
1. Store the trimmer away from direct sunlight.
2. Do not store in a nylon bag as this can encourage the
formation of mould.
3. At the end of the season, give the trimmer an overall
cleaning and a thorough check.
4. Do not leave the trimmer resting on the floor for extended
periods as it could cause the shape of the guard to
alter, posing a safety risk. Hang it off the floor by the top
handgrip.
5. Place the battery on charge and charge to approx
50-75% charge level. Remove the battery pack from the
tool for storage.
18