909 EDG4 Buku Petunjuk - Halaman 12

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mesin Pemotong Rumput 909 EDG4. 909 EDG4 13 halaman. 1200w lawn edger

Halaman Cetak

Note:

Edging of heavily overgrown edges and damp soils

can create greater build-up of difficult to remove waste. It

may be necessary to remove the bulk of this material using

a long thin implement (ie. screwdriver).

Maintenance

Changing the Blade

WARNING:

Before performing any maintenance or tool

adjustments ensure the power supply cable has been totally

disconnected from the mains power.

1. Place a 25mm spanner over

the outer blade flange and

use a 14mm spanner to

remove the lock nut in an anti-

clockwise direction. Remove

the lock nut, outer flange and

the blade and ensure the shaft

and inner flange are clean of

any dirt, etc.

2. Fit the new blade and outer flange and ensure all is

located correctly, as shown. Fit the lock nut and tighten

firmly using both spanners.

3. After the blade is secure, rotate the blade by hand

to ensure the blade is not making contact with any

components of the edger.

Blade wear is expected whenever you use your edger.

Blades wear quite quickly when edging along concrete

paths. This does not effect the efficiency of the edger

and is expected due to the aggressive abrasion of

concrete on steel.

Edger Blades are not a warranty item! Edger Blades

are available from your local Hardware store or can be

purchased direct from AUTOMATIC. See details on the back

page of this manual.

Before performing any maintenance or tool adjustments

ensure the power supply cable has been totally

disconnected from the mains power.

Cleaning

CAUTION.

Use only mild soap and a damp cloth to clean

the tool.

Never allow any liquid to get inside the tool, never immerse

any part of the tool into a liquid.

Preventing Corrosion

Fertilizers and other garden chemicals contain agents that

greatly accelerate the corrosion of metals. If you use the

tool in areas where fertilizers or chemicals have been used,

the tool should be cleaned immediately afterwards. Wipe

all exposed parts with a damp cloth. You may lubricate only

metal parts with a light petroleum based oil. When cleaning,

never immerse in water or squirt it with a hose.

General inspection

Regularly check that all the fixing screws are tight. They

may vibrate loose over time.

Repairs

Only an authorised service centre should replace the

cordset or effect other repairs. If the cordset is damaged

or worn, have it repaired or replaced by an authorised

service centre.