Galaxy Audio TV10 Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembicara Galaxy Audio TV10. Galaxy Audio TV10 7 halaman. Wireless portable sound system plus txrm stationary transmitter

E. LCD Indications:
CH . OB
1. IEJ
I :Three bars means batteries are fully charged.
CH . OB
2. I CJ
I :One bar indicates low batteries. Replace or recharge the batteries.
3.
:No bars
showing indicates batteries are exhausted and after flashing three times the power will
CH OB
10
I
_
�. __ . -�· automatically shut off.
F. Battery Charging Steps:
1. Rechargeable batteries need to be NiMH AA 1.2V with an amperage of 2100mAH or less as the charging function is
limited to batteries of this rating.
2. Recharging is best accomplished by using the AS-DCTVHH charger.
3. Char in Status:
CH . 08
a.
[J
Battery indicator flashing: Non-Rechargeable batteries installed or no batteries installed. Check the batteries.
CH . OB
b J_:
I � attery indicator is flashing and LCD backlight is on: Failing, corroded, or over-temperature batteries.
H. 0 8
j
c. lCJ
One or two bars showing: Batteries are charging successfully.
1[
I
I
CH . 08
El
d.
Three bars showing: Batteries have been fully charged.
* Please note the microphone will be turned off automatically while it is being charged.
G. Troubleshooting:
1. LED doesn't light when power switch is pressed to turn on mic.
a. Make sure that the batteries are not discharged.
b. Make sure that the batteries are installed correctly.
I
fr
2. LCD Shows
r
a. Press the SET, UP and DOWN buttons at the same time in order to turn the microphone off automatically. The LCD
display will flash about ten times and then the microphone will turn off automatically. The microphone should now turn
on and off normally.
b. If the problem persists, call for service.
3. LCD panel shows unusual indications.
a. Remove the batteries from the microphone and re-install them.
4. No audio from microphone.
a. Check that the frequency of the transmitter is the same as that of the receiver.
b. Make sure that the Mic switch is not set to Mute.
c. Check if the distance between the transmitter and the receiver is too great.
d. Check if the transmitter or the receiver is too close to any large metal objects.
e. Make sure receiver and master volume are up.
5. Interference and signal disturbance.
a. Make sure there are no other wireless systems operating on the same frequency in the same area. This includes
Microphones, televisions, radio stations, etc. Try setting the transmitter and receiver to a new channel.
H.Q&A
Q: How long can the microphone be operated with fully charged batteries?
A: Re-chargeable batteries will last approximately 8 to 10 hours. Disposable batteries will last approximately 13 hours.
Q: How much time is required to recharge batteries from a fully exhausted state?
A: Approximately 4 to 5 hours.
I
when power switch is pressed to turn mic off.