DynaQuip Controls WaterCop Panduan Pemilik & Panduan Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pemilik & Panduan Instalasi untuk Unit Kontrol DynaQuip Controls WaterCop. DynaQuip Controls WaterCop 8 halaman. Emergency leak detection and water shut-off system

Halaman Cetak

When water comes in direct contact with a

WaterHound sensor, an RF (radio frequency) signal is

transmitted to the WaterCop

turning off the water source to protect the building from

additional water damage. The red indicator light will

signal that the valve is now in the closed position, and

that you need to check all areas where you have

placed a WaterHound to determine what plumbing

product caused the system to activate. The valve will

remain closed until the unit is reset on the WaterCop

panel. After the plumbing problem is fixed, reset the

WaterCop

by pressing "open valve" (green circle) on

the face of the WaterCop

indicator will be lit. See illustration to the lower left.

Note: If major repairs are needed to correct the

plumbing system, it is recommended that the manual

shut-off valve upstream of the WaterCop

closed during the repairs. Close the main water shut-

off valve and unplug the WaterCop

repairs on the plumbing system.

Note:

In case of a power failure, the WaterCop

cannot operate. If the power is out, you will need to use

the manual shut-off valve to turn the water off in case

of an emergency.

When power is restored, the

WaterCop

will remain in its last known position indi-

cated by the red or green lights on the face of the unit.

WaterCop

Specifications

Max. working pressure ...125 PSIG

Ambient temperature .....35° to 105° F

Enclosure .......................Polycarbonate

Voltage ...........................115, 1 Phase, 60 Hz

Current ...........................2.5 Amps

Power Input:

Standby ..........................1.375 W

Holding (2.5 sec) ............75 W

Power Cord ....................8 ft. Heavy-Duty Grounded

Valve ..............................Full-Port, Brass, NPT

Valve Seals ....................RTFE

Flow Data

Valve Size Cv = Gpm flow @ 1 PSI pressure drop

1/2" NPT

3/4" NPT

1" NPT

For cold water applications.

and the valve closes,

. Valve will open and green

also be

before doing

FCC Information

This equipment has been tested and found to comply

within limits of a class B digital device, pursuant to part

15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful

interference in a residential installation.

equipment generates, uses, and can radiate radio

frequency energy and if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications. However, there

is no guarantee that interference will not occur in a

particular installation.

The water sensors only transmit a radio signal during

testing and when contact is made between the probes

as when water is detected. This signal is of a 2-second

duration and is repeated approximately every 6

seconds while activated. This 2 second signal should

be the only time potential interference could be

detected. If you suspect the unit is interfering with your

radio and/or television reception on a prolonged basis,

remove batteries from all transmitters to determine if

this unit is causing the interference. If so, please

consult your dealer.

LIMITED WARRANTY

DynaQuip

Controls

WaterCop

to be free from defects in material and

workmanship under normal use and if properly

installed for a period of three years from the date of

purchase. If found to be defective as mentioned above,

it will be replaced or repaired if returned prepaid along

with proof of date of purchase. This shall constitute the

sole remedy of the purchaser and the sole liability of

DynaQuip Controls Corporation. To the extent

permitted by law, the foregoing is exclusive and in lieu

of all other warranties or representations whether

expressed or implied, including any implied warranty of

merchantability or fitness. In no event shall DynaQuip

Controls Corporation be liable for special or

consequential damages.

Corporation

warrants

This

the