909 HT8750-AUOXY Buku Petunjuk - Halaman 8

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Inverter 909 HT8750-AUOXY. 909 HT8750-AUOXY 16 halaman. 500 watt

Halaman Cetak

CAUTIONS

•

If turning the On/Off switch off, then on again does not

reset the converter, DO NOT ATTEMPT TO OPEN THE

CONVERTER. Opening the converter for any reason

will void the warranty. The unit must be-returned to

manufacturer for testing and repair by professional factory

technicians.

•

Exceeding recommended voltage limits will void

manufacturer's warranty.

•

NEVER try to use your converter with any 12 volt DC

power source that uses a positive ground. (Most vehicles

and boats use negative ground systems.)

•

The Power Converter must be connected only to batteries

with a nominal output voltage of 12 volts. The unit will not

operate from a 6 volt battery and will sustain permanent

damage if connected to a 24 volt battery.

•

Reverse polarity connection will result in a blown fuse

and may cause permanent damage to the converter.

protective features

The converter monitors the following conditions:

Input Voltage Too Low: This condition is not harmful to

the converter, but could damage the power source, so the

converter will automatically shut down when input voltage

drops below 10.5 ± 0.5 volts DC.

Input Voltage Too High: The converter will automatically

shut down when DC input voltage exceeds 15.4 ± 0.5 volts,

as this can harm the unit.

Thermal Shutdown Protection: The converter will

automatically shut down when the unit becomes

overheated.

Overload/Short Circuit Protection: The converter will

automatically shut down when an overload or short circuit

occurs.

Note: The Power/Fault LED Indicator will light solid to

indicate that the converter is properly connected. The

Power/Fault LED Indicator will flash to warn of a fault

condition before automatic shutdown occurs.

Rated versus actual current

draw of equipment

Most electrical tools, appliances, electronic devices and

audio/visual equipment have labels that indicate the power

consumption in amps or watts. Be sure that the power

consumption of the item to be operated is below 500 watts.

If the power consumption is rated in amps AC, simply

multiply by the AC volts (240) to determine the wattage.

Resistive loads are the easiest for the converter to run;

however, it will not run larger resistive loads (such as

electric stoves and heaters), which require far more wattage

than the converter can deliver on a continuous basis.

Inductive loads (such as TVs and stereos) require more

current to operate than do resistive loads of the same

wattage rating.

For safety reasons, the converter will simply shut down if it

is overloaded. To restart the unit, simply unplug all devices

plugged into the converter; disconnect the converter from

any 12 volt DC power source; then reconnect the converter

BEFORE plugging the appliance(s) back in.

Installation

Your converter will provide you with continuous electrical

power when powered by a reliable 12 volt DC source, such

as a vehicle battery or a multiple battery configuration. This

manual does not describe all of the possible configurations.

Mounting the converter

The converter comes equipped with mounting brackets for

long-term installation. Secure the converter using screws

appropriate to the mounting surface (not supplied). Use

ONLY non-corrosive marine fasteners and fittings for marine

installation.

CAUTION To avoid the risk of property damage, only mount

the converter on a level, stable surface, assuring that all

screws are tightened securely and observing all of the

cautions and recommendations regarding installation found in

this manual.