911SafeTrack S4 Panduan Instalasi - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk GPS 911SafeTrack S4. 911SafeTrack S4 20 halaman. Vehicle security tracker

Step 5 – Connecting Cable (continued #2)

Vehicle Alarm (yellow) -- Using the shop manual diagram

locate the wire from the vehicle security module that sounds

the alarm horn. Use the Installation Kit wire connector to

attach to the yellow wire going to the S4. Be sure to

review Step 7 -- Testing.

Note: If your vehicle does not have a vehicle alarm or if the

vehicle alarm does not work or if you don't want the vehicle

alarm to alert the S4, you can leave the yellow wire

unconnected and cover the end with electrical tape. If your

vehicle does not have a vehicle alarm but has a keyfob

"Panic" button, you can connect the security module output

to the yellow wire to alert S4 if you press the panic button

for more than 8 seconds.

12v Power (red wire with fuse) -- Using the shop manual

diagram, locate the relay contact connection that provides a

constant 12-volt level (shown on your multimeter)

regardless of whether the ignition key is On or Off. The

manual may say, "HOT AT ALL TIMES." Note: Standard

ODB diagnostic connector adjacent to the steering column

has the HOT AT ALL TIMES on pin 16. Connect the S4 red

wire to the existing vehicle wire using one of the S4

Installation Kit wire connectors to capture the vehicle wire

and use pliers to squeeze tightly.

911SafeTrack.com