911SafeTrack S4 Panduan Instalasi - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk GPS 911SafeTrack S4. 911SafeTrack S4 20 halaman. Vehicle security tracker

Step 7 – Testing Basic S4 Operations (continued)

Now the Installer can turn Off vehicle ignition and trigger the

vehicle alarm (or keyfob "Panic") for at least 8 sec. The

S4 can be programmed by SMS to detect an alarm signal

that is either high (12v) or low (0 v). When S4 receives

the correct high or low alarm output signal, Installer will

receive an Alarm Sounding text notification. This confirms

that the alarm connection is proper. If terminal 7 goes to

12v for alarm, Installer needs to send: 12345 at*alarm=1

(note space after PIN). 12345 at*alarm=0 changes the

alarm detection from high to low (note space after PIN).

If Out #1 has been connected, the Installer should check by

sending: 12345 relay on (note space after PIN and space

after relay). The S4 will turn on the relay and the starter

will be disabled. Then the Installer should send: 12345

relay off (note space after PIN and space after relay).

The S4 will turn the relay off and the starter will function

normally.

If Out #2 has been connected, the Installer should check by

sending: 12345 pulse (note space after PIN). The S4 will

cause Out #2 to pulse for 1 second, which should activate

that function (door unlock, door lock, flash headlights,

sound horn, etc.) that was chosen by the Owner.

Now the Installer should send:

12345 at*user=0,OwnerMobileNumber,1 (note space

after PIN). This sets the Owner's number in the S4.

Installation is now complete.

911SafeTrack.com