Autool CT-200 Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Diagnostik Autool CT-200. Autool CT-200 14 halaman. Injector cleaner & tester
Juga untuk Autool CT-200: Manual (18 halaman), Panduan Pengguna (14 halaman)

Halaman Cetak

Figure.02

1-LED screen; 2-Start; 3-Arrow key; 4-PAUSE; 5-Arrow

key; 6-STOP; 7-Pressure down; 8-Pressure up;

9-Pressure Meter

Operating Procedures

Preparation

Remove the injector from the vehicle and carefully check

the rubber seal of the injector for damage. If it is

damaged, replace the same type of seal before the

cleaning test, in order to avoid leakage during the test.

Put the nozzle into gasoline or detergent, carefully

remove the external oil and wipe it with a soft cloth.

Check and add the test solution. Fill the fuel tank from

the fuel filler port on the side of the main unit and

observe the liquid level pipe on the side. Generally, 1/2

capacity of the tank is enough.

Press the power switch and backlight switch on the right

side of the main unit.

Add an appropriate amount of cleaning liquid or special

ultrasonic cleaning liquid to the ultrasonic cleaning tank,

and dip the nozzle needle valve.

Select the corresponding injector connection coupler.

Note: This equipment requires a special test solution and

cleaning agent. The test solution is used by the host during

uniformity detection/atomization observation, sealing test,

fuel

injection

quantity

detection

detection. The main engine uses gasoline plus cleaning

agent during the cleaning. The ultrasonic cleaner uses a

special ultrasonic cleaner.

Cleaning and Testing Sequence

Generally complete cleaning test procedure is recommended

in the following order.

Ultrasonic cleaning;

Uniformity/Sprayability test;

Leakage test;

Injecting flow test;

Automatic test.

According to different test items, select the corresponding

parameters in the parameter selection field and set them.

For details, please refer to the " Operation Procedure

Description".

After Operation

After the cleaning and testing work is finished, it should be

cleaned up, including:

Press the control panel drain button to return the test

fluid to the tank.

Turn off the power switch and unplug the power cord.

and

automatic

cleaning