Dynaset 90 Panduan Instalasi - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pompa Air Dynaset 90. Dynaset 90 16 halaman. Hydraulic variable displacement pump

3. Install the pump to its place. Make sure that the drain line is above or at least at the

horizontal level with the axel. If the pump is installed drain line being under the

shaft it can damage the pump.

4. Install the pressure (P), drain (Dr), LS- (LS), and the suction (S) lines

5. Install the rest of the system and fill the system with oil.

6. After installing the rest of the system and filling it with oil run the system with idle

speed for 10 min at pressure being under 50 bar.

Bleeding/flushing the system is recommended before the full pressure range is

used.

Dynaset Oy | Menotie 3, FI-33470 Ylöjärvi, Finland | tel: +358 3 3488 200 | [email protected] | www.dynaset.com

HYDRAULIC VARIABLE DISPLACEMENT PUMP

INSTALLATION GUIDE