Autool CT-200 Manual - Halaman 4

Jelajahi secara online atau unduh pdf Manual untuk Peralatan Servis Autool CT-200. Autool CT-200 18 halaman. Injector cleaner & tester
Juga untuk Autool CT-200: Panduan Pengguna (14 halaman), Panduan Pengguna (14 halaman)

Halaman Cetak

2）Connect the machine to power supply and turn it on.

3）Put the cleaning frame on the ultrasonic groove, and put the injector

into the whole of the frame.

3.1.2 Steps

01 Ultrasonic Cleaning

1）Pour proper quantity cleaning fluid into ultrasonic groove.

2）Connect the actuation cable to the injector needed to be cleaned.

3 ） Press Left or Right Arrow key to select "Ultrasonic Cleaning" from

panel, then press "RUN"key.

4） Press Left or Right Arrow key to set up working time（ default time is 10

minutes）.

5）Press "RUN"key. (You can press PAUSE or STOP at any time during the

operation process.)

6）After the cleaning is completed, it will stop automatically.

7）Take the injector out of the ultrasonic groove.

NOTE：

1. During the cleaning, get the injector close to ear, listen carefully, you

may hear the intermittent sound of closing and opening of the

injector's valve, otherwise the injector's valve is blocked.

2. Please do not turn on the ultrasonic trough when there is not clean

fluid in the trough, otherwise the machine will be damaged.

3.2 Injector Test

This function is to test the condition of atomization, drop, block, spray

angle, and uniformity of the injector.

- - 4 - -