Autopage XT-11 Panduan Pengoperasian - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Starter Jarak Jauh Autopage XT-11. Autopage XT-11 9 halaman. Professional remote car starter
-
Stop remote start operation
** The first push of the
and the second push will stop the engine.
XT-11 Operations:
1) To remote start the vehicle using the XT-11 press the
twice.
2) To unlock the vehicle on approach, Press the
unlock the doors. If the button is pressed again within 3 seconds,
the remote starter will shut down.
As with any product that performs automatic functions, there are certain
safety precautions that you must practice and be aware of.
1. Keep the transmitter out of children's reach.
2. Do not leave anyone in the vehicle while running on remote control.
3. Alert servicing personnel that the vehicle can be started automatically.
4. Do not start the vehicle by remote while it's in an enclosed area or
garage.
5. Always apply the parking brake and lock the vehicle as you exit the
vehicle.
6. Should the unit malfunction, disconnect the fuse until the problem is
corrected.
7. The use and operations of this system is the sole responsibility of the
operator.
8. Some areas may have local ordinances that prohibit leaving a vehicle
running on public streets.
A. TO REMOTE START THE VEHICLE:
When you want to start your vehicle,
1. Press
button TWICE on either remote transmitter.
2. The parking lights will flash to indicate the remote start received the
signal.
3. The engine will start in approximately 5 seconds.
4. Once the engine is running, after a couple of seconds the parking light
will turn on again and climate controls will activate and adjust the
vehicles interior temperature to your preset setting.
5. The vehicle will run for 5 to 30 minute cycle and automatically shut
down. The duration of the starting mode is programmable.
(SINGLE PUSH, START OPERATION :)
RS60 Op ODG
button will send an unlock signal to the doors
REMOTE START OPERATION:
WARNINGS:
**
Push Twice to stop engine
3
Sept/2009
button
button once to