Autopage C3-RS-730 LCD Panduan Pengoperasian - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Alarm Mobil Autopage C3-RS-730 LCD. Autopage C3-RS-730 LCD 18 halaman. Professional 2-way lcd remote car starter & alarm system with built in temperature, voltage sensor and two-way serial port data link
Halaman Cetak
SVMASTER -
1.When the Ignition is ON press
press
Under ignition ON , press and hold the
lights will turn on for 1.5 seconds to indicate the system has entered the anti car-jacking mode.
2. Once the system in anti car-jacking mode, the system will be triggered when any door i s opened and
closed while the ignition is "ON".
PASSIVE ANTI CAR - JACKING: (Programmable)
It will operate as noted below:
1. Turn the ignition switch to the "ON" position and the system will arm.
2. Once the system is armed, if you are forced from the vehicle, the system will trigger when the door is
opened and closed while the ignition is "ON".
TRIGGERING THE ANTI CAR -JACKING MODE:
A). 50 seconds after the system has been triggered. The siren will start chirping for 15 seconds.
B). During this 15 second period of chirping, you will be alerted to push the valet switch once to turn off the
car-jacking feature. If not, it will enter a second timer for carjacking.
C). 65 seconds after the system has been triggered, the siren will start sounding and the par king lights will
start flashing.
D). 90 seconds after the system has been triggered,
1.
The siren will sound and the parking lights will flash, and
2.
The starter disable will activate to prevent the vehicle from starting.
3.
It will remain active until the vehicle's battery power is exhausted.
OVERRIDE THE SYSTEM TO TURN OFF ANTI CAR- JACKING:
Turn the ignition switch from OFF to ON, and within 10 seconds push valet switch, the siren will stop and the
system disarmed
Note: If you use password pin code to doubl e protect the vehicle security, you will need to use it to completely
disarm the system.
N. SYSTEM'S TRIGGER CHECK
Press and hold
LCD remote will show "ALARM " icon flash on text area (see advanced users mode), then press
button to activate system trigger check.
Note: If the system has no response then you are out of range.
O. SYSTEM'S STATUS CHECK
F
Press
button of LCD remote until 3 beeps sound , the LCD remote will show "STATUS " icon flashing
in the text area (see advanced users mode), then press
It responds with one melody sound and all vehicles' status records will immediately displayed on the LCD
screen.
Note: If it has no response then you are out of range.
P. DRIVER PAGING / LOST & FOUND (
This feature is useful the event that someone wants to page the driver of the parked vehicle or someone
cannot find his LCD remote transceiver.
Under the ignition switch "OFF" condition, press and hold the valet switch for 2 seconds to page the driver,
one chirp sound shall be emitted from the vehicle and the paging melody sound continues sounding from
the Remote LCD transceiver.
SVMASTER -
F
button four times while "CAR JACK" is flashing in the text area, then
button to activate Anti Car-Jacking mode or
(For two-way transceiver operation only)
F
button of LCD remote until 3 beeps sound , release and re-press
(For two-way transceiver operation only)
http://www.msvmaster.lv
-
and
buttons at the same time for 2 seconds. The parking
button to activate system status check.
For two-way transceiver operation only)
8
http://www.msvmaster.lv
-
F
button again, the