Autopage RS-600 Panduan Pengoperasian - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Alarm Mobil Autopage RS-600. Autopage RS-600 9 halaman. Professional remote car starter & keyless entry system

Halaman Cetak

CHANGING THE BATTERY IN YOUR TRANSMITTERS

XT-33: The XT-33 transmitter uses two (2) 3-volt lithium ion batteries

(#CR2016) that are sandwiched together with the (+) side facing upward.

To replace the battery, you will need to use a small flat blade screwdriver.

Locate the small notch on the lower right side of the transmitter case

next to the key ring. Using the flat blade screwdriver, carefully pry the

top case from the bottom case. It should snap apart after breaking the

seal. Before removing the batteries note the direction of the positive (+)

terminal. Place the new batteries in exactly the same manner, being

careful not to bend or damage the contact terminal. Snap the cases

back together and then test the transmitter to insure it arms and disarms

the alarm. The procedure for the XT-11 Mini remote will be the same.

Your RS600 remote car starter comes with a secondary remote

transmitter with only one button. This remote will be used in applications,

where the factory keyless entry system is the main source for

arming/locking and disarming/unlocking the vehicle. For example,

vehicles with the factory smart key/ "push button" start or one-piece

remote with key, it is recommended that the main sole purpose for this

transmitter to be used for remote starting the vehicle.

All operational directions are for the XT-33 remote control. The

XT-11 is designed to be used with a factory keyless entry remote

and will only start and stop the engine of the installed vehicle.

XT-11 Mini Remote is for start only.

1 - 3 Volt CR 2032

(2) CR2016

3-Volt Batteries