AUTOPILOT SYSTEMS DIG-220 Panduan Pemilik - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Peralatan Pencahayaan AUTOPILOT SYSTEMS DIG-220. AUTOPILOT SYSTEMS DIG-220 16 halaman. Swimming pool and spa purification system
Halaman CetakSection 1b – GENERAL PRODUCT INFORMATION
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
Follow all National Electric Codes (NEC) unless State or Local guidelines supersedes. When installing
and using your Pool Pilot™ Digital Control Box, basic safety precautions must always be followed,
including the following:
1.
DANGER – Risk of electrical shock. To avoid serious injury or death,
Ensure that the electrical panel or filter pump circuit is turned OFF prior to installation or servicing inside any
Autopilot unit.
Mount the Control Box to ensure the least amount of direct exposure to rain, garden sprinkler water, direct
sunlight, or any corrosive environment.
Install the Control Box at least 10' (3 m) for 115VAC Units, from the inside wall of the pool or spa using non-
metallic plumbing. 5' (1.5 m) minimum distance for 230VAC Units.
2.
DANGER – To avoid serious injury or death, do not permit children to use this product unless they are closely
supervised at all times. Children should not use spas, hot tubs, or pools without permanent adult supervision.
WARNING – To avoid personal injury, maintain water chemistry in accordance with manufacturer's instructions.
3.
4.
All field-installed metal components such as rails, ladders, drains, or similar hardware within 10' (3 m) of the spa or hot
tub shall be bonded to the equipment grounding bus with copper conductors not smaller than No. 8 AWG (8.4 mm²).
A wire connector is provided on your Pool Pilot™ Digital to connect a minimum No. 8 AWG (8.4 mm²) solid copper
1
bonding conductor between this unit and any metal equipment, metal enclosures of electrical equipment, metal water pipe
or conduit within 5' (1.5 m) of the unit.
A bonding terminal is located inside your Pool Pilot™ Digital. To reduce the risk of electrical shock, this terminal must
2
be connected to the grounding means provided in the electrical supply panel with a continuous copper wire equivalent size
to the circuit conductors supplying your Pool Pilot™ Digital.
3
A disconnection device from the power source, with a contact separation of at least 0.12" (3mm) in all poles, must be
incorporated in the fixed wiring for permanently wired units.
The input voltage to the Pool Pilot™ Digital must match the 115/230VAC jumper terminals on the Circuit board, marked
4
"TRANSFORMER PRIMARY", shown on Page 5.
5
The Control Box is provided with (3) knock out holes for electrical conduit connections and has (1) 1/2" Liquidtite fitting
already attached. 1/2" non-metallic flex conduit is recommended.
INSTALLATION AND EQUIPMENT RELATED
Installation of all
Equipment Related
115/230VAC, 50/60 Hz Models (fixed wiring)
SAVE THESE INSTRUCTIONS
™ Digital models:
2