Autoplugin RCP-F2 Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Elektronik Mobil Autoplugin RCP-F2. Autoplugin RCP-F2 16 halaman.

Preparation for Work

· Focus II (2004-2007), C-Max (2003-2006)

Turn on the ignition and select in driver information system (DIS) menu:

Your settings -> Aux.heater programming ->Instant control -> Auto

· Focus II (2008-2011), C-Max (2007-2010), Kuga

Start the engine and select in DIS menu:

Set>Menu –> Settings –> Auxiliary Heating -> On ->Off ->On (again)

1. To start/stop the heater by using additional remote control, see

documentation for the remote control. Functionality of the remote control

depends on its possibilities, connection schemes and module's settings.

2. To start the heater by using the original Ford key press "Lock" button 3

times on the key. Time intervals between presses must not exceed 20

seconds. The unlocking of the vehicle or time interval excess will restart the

counter of "Lock" button presses. Look at the direction indicators to be sure

that RCP has received a command from the key. Every button press on the

key will be confirmed by direction indicators (if the car has been locked

before). Also if the car equipped by keyless entry system, you can use

button on the door handle as "Lock" button to start the heater outside the car

(passive key must be presented). You can see series of double flashes in

direction indicators of rear-view mirrors when the heater starts to operate

(choose setting 6.1.2 to activate this function).

3. The RCP adjusted by default only to switch the heater on by using Ford key.

If you also wish to switch the heater off, change the setting 5.1. As both the

commands use the same combination of "Lock" presses, you should know a

condition of the heater before a command send. Therefore we recommend

you to activate the settings 6.4 – 6.6 to see the heater condition indicated by

turn signals flashing in the rear-view mirrors. The possibility to stop the

heater remotely may be useful in case of cancelation of the trip, including

ones programmed by DIS.

4. You can remotely cancel the start of the heater by a DIS program, if your

additional remote control can send stop command when the heater is idle.

After stop command sending, DIS programs will be temporary disabled.

Start the heater by any way or turn the ignition on enables DIS programs

again.

5. Additionally connected button gives several functions. Current function is

defined by heater, ignition and engine conditions (see table. 3)

When the ignition is turned off, the button is used for immediate start or

stop of the heater. Button press changes heater condition to another one:

switches off the operated heater or switches on the idle heater.