Autoplugin Therminal V2 Panduan Instalasi - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Elektronik Mobil Autoplugin Therminal V2. Autoplugin Therminal V2 12 halaman.

Halaman Cetak

Additional Functions of RCP Can-V2

By default RCP Can is adjusted to execute basic functions, such as start and stop of

the heater by the Volvo key or by additional button. To turn on additional

functions (ex. battery monitoring) you may enter the module into programming

mode and activate the corresponding setting.

The left-side steering wheel lever and the brake pedal are used to enter

programming mode and to the settings change. It is necessary to stop the engine

and the heater before. Turn the ignition on, press and hold the brake pedal. Twist

the lever's ring some steps to turn off the left display in DIS. Then press and hold

"Read" button at least for 5 seconds, while built-in LED is flashing once a second.

Both turn signal repeaters in DIS will flash twice as a confirmation of entering

programming mode. Release the brake pedal and "Read" button now.

Each setting in the table 3 corresponds to the 3-digit code. You need to enter

appropriate code to activate a setting. To enter a digit of a code, shortly press

"Reset" button on the lever so much times, as corresponds to a digit. Each button

press will be confirmed by the LED flashing and by a turn signal repeater of DIS:

the left turn to the first and the third digits of code, the right turn to the second digit

of code. To confirm a digit entering, press and release "Read" button (DIS will

flash one time by the both repeaters simultaneously). After the third digit will be

entered, module will check the code for validity and confirm it by repeaters: flash

twice by the both repeaters simultaneously in the case of valid code, flash twice by

the both repeaters alternately in the case of invalid code.

If you made a mistake with the number of button presses when you enter the code,

press and release "Read" button until the module will indicate an error by

repeaters. Enter the code again in that case. Also you may enter other codes

without exit of programming mode.

Turn the ignition off to exit programming mode. New settings will be saved in the

module's memory and will be stored there regardless of whether the module is

connected or not. Attention: If you start the engine without exit of programming

mode, new settings will not be saved in memory.

To reset the module to factory settings, enter the code 8.1.1. Both repeaters will

flash three times to confirm command execution, and then the module will exit of

programming mode and will restart.

Settings

Setting

Group

1.1. Limitation of

Heater

heater's total

Timing

operational time, in

pre-heat mode

Possible Values

1.1.1 Not adjusted

1.1.2 40 minutes

1.1.3 50 minutes

1.1.4 60 minutes

1.1.5 *70 minutes

1.1.6 80 minutes

1.1.7 90 minutes

Settings Table (3)