Autopot 100Pot system Pengaturan Manual - Halaman 2
Jelajahi secara online atau unduh pdf Pengaturan Manual untuk Sistem irigasi Autopot 100Pot system. Autopot 100Pot system 2 halaman.
Halaman Cetak
100Pot system contents
• 1x 750 litre FlexiTank
• 2x 16mm tee connector
• 100x 1Pot tray and lid
• 50x 16 - 6mm cross connector
• 100x 15 litre pot
• 40 metres of 16mm pipe
• 100x AQUAvalve
• 50 metres of 6mm pipe
• 1x 16mm click-fit tank adapter and filter
• 100x marix disc
• 5x 16mm inline tap
• 100x root control disc
Suggested layout
System requires minimum
750 litre FlexiTank (supplied)
750 ltr
FlexiTank
750 ltr
Elevate tank
FlexiTank
150mm from
floor to maintain
Elevate tank
gravity pressure
150mm from
floor to maintain
gravity pressure
AQUAvalve
16mm click-fit tank adaptor & filter
6mm pipe
16mm pipe
•
Pot up your plants, water through, then allow your plants to establish in the pots for a period of 7 to 10
days before turning your system on. This will encourage a stronger and healthier root system.
•
Always raise your tank to a minimum of 150mm above the highest AQUAvalve and re-fill the tank when
there is approximately a 1/3 of the solution left - NEVER ALLOW THE TANK TO RUN EMPTY.
•
For best results, we recommend mineral fertilisers. Do not use organic fertilisers, as they have a tendency
to block small pipe work.
•
Clean all substrate from the bottom and sides of the pots before placing in each tray.
This will ensure your system is clean from the start.
•
Always use free draining substrates, for example: soil/perlite, coco/perlite, soil/clay pebbles,
coco/clay pebbles, rockwool/clay pebbles.
[email protected] I www.autopot.co.uk I +44 (0)844 8581520
Plan views
and options
16mm tee connector
16mm – 6mm cross connector
16mm cross connector
16mm in-line tap
Advice
1Pot dimensions
1
Put black marix
disc in pot
3
Remove collar
Push 6mm pipe through
collar and attach to
AQUAvalve nozzle
Rescrew collar - DON'T
overturn... when you
feel it grip STOP
5
Position tray
so it is level
Insert root control
disc Gold face up
7
According to the size of your system connect your
6mm/16mm pipe to relevant fitting or tank...
Using your front instruction sheet, repeat the module set up instructions for the number of trays.
Allow your plants to establish for 7-10 days before turning system on
Advice
If you require any guidance email - [email protected]
1Pot setup
instructions
750 ltr
FlexiTank
900mm
2
Fill pot with medium
and pot up plants.
Water through pot
and allow to drain
outside the tray.
4
Connect AQUAvalve
so 'half moon' is on
T section in the tray
6
Cut 6mm/16mm pipe
to appropriate length
8
Place
pot
in
the
tray, make sure it is
CLEAN!
Place lid over valve
onto tray