Autopot 4Pot XL Pengaturan Manual - Halaman 2
Jelajahi secara online atau unduh pdf Pengaturan Manual untuk Sistem irigasi Autopot 4Pot XL. Autopot 4Pot XL 2 halaman.
Halaman Cetak
4Pot XL system contents
• 1x 47 ltr tank and lid
• 2x 6mm in-line tap
• 4x 1Pot XL tray and lid
• 2x 6mm cross connector
• 4x 25 ltr pot
• 4x 6mm tee connector
• 4x AQUAvalve
• 4 metres of 6mm pipe
• 1x 6mm top hat grommet
• 4x XL root control disc
• 1x 6mm golf filter
Layout 1
Suggested layouts
47 ltr
Tank
Layout 1
47 ltr
Tank
Layout 2
Layout 2
47 ltr
Tank
47 ltr
Tank
AQUAvalve
6mm golf filter
AQUAvalve
6mm top hat grommet
6mm golf filter
6mm pipe
6mm top hat grommet
6mm pipe
• P ot up your plants, water through, then allow your plants to establish in the pots for a period of 7 to 10 days
before turning your system on. This will encourage a stronger and healthier root system.
• A lways raise your tank to a minimum of 150mm above the highest AQUAvalve and re-fill the tank when
there is approximately a 1/3 of the solution left - NEVER ALLOW THE TANK TO RUN EMPTY.
• F or best results, we recommend mineral fertilisers. Do not use organic fertilisers, as they have a tendency to
block small pipe work.
• C lean all substrate from the bottom and sides of the pots before placing in each tray.
This will ensure your system is clean from the start.
• A lways use free draining substrates, for example: soil/perlite, coco/perlite, soil/clay pebbles,
coco/clay pebbles, rockwool/clay pebbles.
[email protected] I www.autopot.co.uk I +44 (0)844 8581520
Plan views
and options
Connect your 6mm pipe
to the relevant fitting
6mm tee connector
6mm cross connector
6mm tee connector
6mm inline tap
6mm cross connector
6mm inline tap
Advice
1Pot XL dimensions
330mm
380mm
25 ltr
pot
275mm
1
Place circular
root control disc
gold face down
in the pot.
3
Remove collar.
Push 6mm pipe through
collar
and
attach
AQUAvalve nozzle.
Rescrew collar - DON'T
overturn... when you feel
it grip STOP.
5
Position tray so it is
level.
7
8
Push 6mm top hat grommet
Inside the tank push
into tank, then push 6mm
6mm filter into 6mm pipe.
pipe through grommet.
Using your front instruction sheet, repeat the module set up instructions for the number of trays.
Allow your plants to establish for 7-10 days before turning system on
Advice
If you require any guidance email - [email protected]
375mm
4Pot XL system
setup instructions
47 ltr
tank
300mm
2
Fill pot with medium
and pot up plants.
Water through pot
and allow to drain
outside the tray.
4
to
Connect AQUAvalve
so 'half moon' is on T
section in the tray.
6
Cut 6mm/16mm pipe
to appropriate length
8
Place
pot
tray, make sure it is
CLEAN!
Place lid over valve
onto tray.
in
the