Autopot AQUAvalve easy2grow Kit Manual - Halaman 2

Jelajahi secara online atau unduh pdf Manual untuk Peralatan Rumput dan Taman Autopot AQUAvalve easy2grow Kit. Autopot AQUAvalve easy2grow Kit 2 halaman.

Halaman Cetak

easy2grow Kit contents

• 1x 12.4 gal reservoir and lid

• 1x 1/4" golf filter

• 1x 2Pot tray & lid

• 1x 1/4" in-line tap

• 2x 2.2 gal pot

• 5ft of 1/4" pipe

• 1x AQUAvalve

• 2x Root Control Sheet

• 1x 1/4" top hat grommet

• 2x PotSock Square

Suggested layout

12.4 gal

reservoir

12.4 gal

reservoir

AQUAvalve

¼" golf filter

¼" top hat grommet

• P ot up your plants, water through, then allow your plants to establish in the pots for a period of 7 to 10

days before turning your system on. This will encourage a stronger and healthier root system.

• A lways raise your reservoir to a minimum of 6" above the highest AQUAvalve and re-fill the reservoir

when there is approximately a 1/3 of the solution left - NEVER ALLOW THE RESERVOIR TO RUN EMPTY.

• F or best results, we recommend mineral fertilisers. Do not use organic fertilisers, as they have a tendency

to block small pipe work.

• C lean all substrate from the bottom and sides of the pots before placing in each tray.

This will ensure your system is clean from the start.

• A lways use free draining substrates, for example: soil/perlite, coco/perlite, soil/clay pebbles,

coco/clay pebbles, rockwool/clay pebbles.

[email protected] I www.autopot-usa.com I +(1) 562 612 4182

Plan views

and options

Connect your 1/4" pipe to the

relevant fitting

¼" pipe

¼" inline tap

Advice

easy2grow dimensions

22.6"

9.6"

2.2 gal

pot

7.6"

Put Root Control

Sheets in pots

gold face down.

Remove collar.

Push 1/4" pipe through

collar and attach to

AQUAvalve nozzle.

Rescrew collar - DON'T

overturn... when you

feel it grip STOP.

Fit PotSock Squares

over the bases

of the pots

Push 1/4 "top hat grommet

Inside the reservoir push

into reservoir, then push 1/4"

1/4" filter into 1/4" pipe

pipe through grommet

Using your front instruction sheet, repeat the module set up instructions for the number of trays.

Allow your plants to establish for 7-10 days before turning system on

Advice

If you require any guidance email - [email protected]

14.5"

easy2grow Kit

setup instructions

9.6"

12.4 gal

reservoir

11"

Fill pots with medium

and pot up plants.

Water through pots

and allow to drain

outside the tray.

Connect AQUAvalve

so 'half moon' is on

T section in the tray.

Position tray

so it is level

Cut 1/4" / 1/2" pipe to

appropriate length.

Place both pots in

tray, make sure they

are CLEAN!

Place lid over valve

onto tray.