2HEAT RF Series Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Termostat 2HEAT RF Series. 2HEAT RF Series 11 halaman.

Halaman Cetak
Setting...
4. Temporary temperature change:
At
"Automatic" mode it can temporarily change the temperature at a given program period.
For example:
You have set the program already the comfort temperature is 20
18:00, but you want to lower the temperature to 18
℃
18 . This setting will not exist forever, it will remain until 18:00 when the program period is ended.
At
"Automatic" mode set the required temperature directly through
number representing the temperature will flash, and your adjusted temperature will be displayed
without further adjustment in 5 econds after the adjustment. The number representing the
temperature will stop flashing and continuously to display the present room temperature.
The automatic chronothermostat will recover to automatic mode at the following program
temperature changes.
：
Note
Moving the function change-over switch can cancel the temporary temperature change
setting.
5. Interchanging and application of Ex-work preset program and personal setting program;
A. At
mode, keep pressing
displayed at the working state display area, and the temperature controller will take out the ex-
work preset program as the automatic control program.
B. Keep pressing
personal set program mode. At this time
the working mode display area.
C. These two kinds of program modes can be alternated.
6. External power supply
When inserting or taking out of 4V external DC power supply, it will not influence the mode,
operation and memory of the chronothermostat.
7. Adjustment and calibration of the temperature
Adjustment and calibration of the temperature: When the SET key is at the antifreeze mode, keep
pressing
key for 3 seconds the LCD screen will reveal
key at the same time, press
+0.5 degree or -0.5 degree. After releasing
adjusted and calibrated temperature is
8. Code matching
For RF model: Press the learning button in receiver once, then the indicator light will flash.
Turn the change-over switch of sender to OFF position to turn off the LCD, press
key at the same time. The match is finished when the indicator light put out.
For MRF model: Press the leaning button in receiver one time (the indicator light flash one
time in every 0.5 sec) to match the No.1 of transmitter. The method of matching in sender is the
same with the single RF.
Press the leaning button in receiver two times (the indicator light flash two times in every 0.5 sec) to
match the No.2 of transmitter. Press three times (the indicator light flash three times in every 0.5
secretary) to match the No.3. Press the button four times (light flash four times) to match the No.4.
，
，
key for 5 seconds, then: the
key long for 5 seconds again, the temperature controller will return to the
：
，
or
key each time the original tested value will be rectified by
± ℃
3 .
，
℃
，
at 10:00 then you set the temperature to
and
program symbols will be displayed at
：
，
key the word
℃
between 9:00~
key or
key, the
symbol will be
symbol. While pressing
disappears. The maximum
key and
>7