Dynatech V-4000 PLUS Instruksi Pengguna - Halaman 9
Jelajahi secara online atau unduh pdf Instruksi Pengguna untuk Penguat Dynatech V-4000 PLUS. Dynatech V-4000 PLUS 14 halaman.
Halaman Cetak
P R O F E S S I O N A L
P O W E R
A M P L I F I E R
Front Views & Rear Views | Introduction | Front Panel | Rear Panel | SET UP |
Operating Modes
STEREO OPERATION :
channels one and two of the amplifier. Connect your speakers to the outputs on the rear of the amplifier. Be sure that
your front gain controls are turned down to their lowest level (fully counter-clockwise). Turn your amp on. Turn your input
source level up. Use your front gain controls to regulate the output volume. Be sure not to raise the volume to the clip
level, however an intermittent clip signal is acceptable.
V-3000 PLUS
Rear Panel
SPEAKERS
2 OHM MINIMUM
MONO BRIDGE OPERATION :
other audio equipment are powered down. Flip the Parallel/Stereo/Mono Bridge switch to the Mono Bridge position.
Connect an input signal to channel one. Connect your speaker across the red output binding post on the rear of your
amplifier. Turn your equipment on (your amplifier should always be the last item you turn on). Apply an input source
signal to your amplifier. Use the channel one gain control to regulate your amplifier output.
V-3000 PLUS
Rear Panel
V-3000 PLUS / V-4000 PLUS
Page 8 / Figure 11 detail examples of a typical stereo set-up. Connect your inputs into
CH-2
Input
Figure 11 TYPICAL STEREO OUTPUT CONNECTIONS
Page 8 / Figure 12 details a mono bridge set-up. Be sure you amplifier and all
Figure 12 TYPICAL MONO BRIDGE SET-UP
Operation Mode
CH-1
Input
CH-1
Only Input
page 8
| Protection | Specifications
SPEAKERS
2 OHM MINIMUM
SPEAKERS
4 OHM MINIMUM