Dynatech QUASAR Petunjuk Penggunaan Manual - Halaman 4

Jelajahi secara online atau unduh pdf Petunjuk Penggunaan Manual untuk Sistem Pengangkatan Dynatech QUASAR. Dynatech QUASAR 14 halaman. Overspeed governor

Halaman Cetak

INSTRUCTIONS: QUASAR Cod: DYN 48.1.07

Fecha: 04/12/2017 Revisión: 07

1 GENERAL INSTRUCTIONS

Quasar overspeed governor is a compact governor with a 120-mm pulley.

This governor is of a standard type, that is to say, it may be installed both in the machine room and within the shaft.

Its reduced size makes its installation easier in those locations where saving space is a key factor

This governor is designed to be installed on homelifts and lifts with little or reduced traffic.

In case of overspeed, the governor trips the safety gear to stop the car.

It is strictly forbidden:

a) To modify or replace the overspeed governor adjustment spring.

b) Use an overspeed governor in a lift for which it is not intended, or whose features do not correspond to those

marked on the lift (e.g. nominal speed or rope type).

c) To adjust any component of the overspeed governor, except for those parts specified in the manual.

DYNATECH DYNAMICS & TECHNOLOGY, SL will not be liable for any damage caused by failure to observe any

of these general conditions.

2 OVERSPEED GOVERNOR IDENTIFICATION

3 MAIN COMPONENTS

Please find below a figure of the Quasar governor displaying its main components.

Note: This manual displays partial information on the instructions for use and maintenance of this product. Please refer to the customer

area in Dynatech's website in order to consult the full manual; http://customers.dynatech-elevation.com/

OVERSPEED GOVERNOR IDENTIFICATION LABEL

Governor model

Governor type

Performance speed

(m/s)

Rated speed (m/s)

Serial number

Rope diameter (mm)

QR product traceability code

Dynatech address

Quality assurance CE marking

and notified body number

EU type examination certificate

number